Installation Instructions
Verifying the Package Contents
•Use and care manual
•Mounting screws
•Wire rack with mounting hardware (IOWO model only)
Removing the Drawer
WARNING
1.Verify that the electrical outlet for the warming oven meets the Power Supply Requirements on the facing page before proceeding.
2.Be certain that power plug is disconnected from the electrical outlet before installation.
Remove the drawer from the appliance to allow access to the mounting holes during installation, and to reduce weight:
1.Pull the drawer out to the fully open position.
2.Push in on the locking tab on one side as you pull the drawer up.
3.When the drawer comes loose on the slide, repeat the same process on the opposite side.
4.Grip the drawer on both sides and pull it free.
5.For safety, push both drawer slides into the drawer opening.
STEP 2: Push locking tab
STEP 3: Pull up on front of drawer
Drawer Slide
Installing the Chassis
WARNING
To avoid personal injury caused by the appliance falling forward when the drawer is opened, secure the chassis to the cabinet and support platform as instructed.
1.Grasp the warming oven chassis on opposite sides and slide it partially into the cabinet opening.
2.Temporarily support the oven in place so that it will not tilt or fall.
3.From an adjoining cabinet, reach in behind the oven and pull the power cord until the plug is next to the electrical outlet. Do not plug in the power cord at this time.
4.After positioning the power cord and plug, slide the chassis completely into the cabinet until the front frame is positioned flush against the cabinet face.
5.Use the screws provided to secure the warming oven chassis to the cabinet and support platform, (You may want to drill pilot holes prior to installing the mounting screws.) Install one mounting screw through the hole provided in the front. A pair of holes go through the side of the chassis for mounting to the cabinet walls.
continued...
7