Installation Instructions

Door and Drawer Front Removal

Some installations require door and drawer front removal before transporting the refrigerator through doorways to the location where it will be used.

WARNING

Electric Shock Hazard Disconnect power before removing doors.

Failure to do so can result in death or electrical shock.

TO REMOVE THE DOOR:

TO REMOVE THE DRAWER FRONT:

1. Pull the freezer drawer completely open.

2. Tilt the lower basket forward and lift to remove.

3.Loosen the four (4) screws attaching the drawer brackets to the drawer front as shown below.

NOTE: Loosen the screws only three to four turns. Do not remove the screws from the drawer front.

1. Unplug the power cord from the power source.

2. Remove the toe grille.

Hinge Cover

3. Remove the top hinge cover from the refrigerator door by removing the Phillips screw. Retain the screw and cover for later use.

Loosen screws on both sides of the drawer front.

	4. Unscrew the 5/16” hex head screws	Top Hinge
	from the top hinge. Remove the
	hinge and retain it and all screws for	4. Lift the drawer front upward and off the screws.
	later use.	4. Lift the drawer front upward and off the screws.
	later use.

5. On 3 door (french door) models, disconnect the wiring plug located on top of the left top hinge by wedging a flat-blade screwdriver between the two sections.

6. Lift the refrigerator door(s) from
center hinge pin.	Wiring Plug
	Wiring Plug

7. Remove the Phillips screws that hold the center hinge in place. Remove the hinge and retain it and all screws for later use.

Center Hinge