Installation Specifications
Rough-In Dimensions
◊The solid sofit or ceiling should be within 1” (25mm) above the refrigerator. If the solid sofit is higher than 1” (25mm) or one is not available, then the refrigerator must be braced to prevent tipping during use. If the
(see “Anti-Tip Blocking” on page 9)
NOTE: A clearance of 1/2” (13mm) must be maintained above the top grill in order for the top grill to be opened.
◊A grounded 3 prong
◊The plumbing for the water line can come through the floor or the back wall. See “Water Supply Requirements” for more information.
“A” |
|
| 2” |
|
| Electrical |
| 7” |
|
|
| 4” |
83 3/4” |
|
|
| 75 1/2” |
|
6” |
|
|
Water Supply | 3” | 24” |
Electrical Requirements
WARNING
Electrical shock Hazard – Plug into a grounded 3- prong
A 115VAC, 60 Hz, 15 Amp circuit breaker and electrical supply are required. A separate dedicated
Your Dacor®
IMPORTANT: A ground fault circuit interrupter (GFCI) is not recommended and may cause interruption of operation.
Water Supply Requirements
◊All installations must meet local plumbing code requirements.
◊Connect to 1/4” (6mm) copper line to the house cold fresh water supply.
◊Use a shut off valve between the refrigerator and supply. The shut off valve should be a drilled saddle valve.
◊Do not use a
◊Route the water line within
◊Allow a minimum of 24” (610mm) dimeter service loop of copper tubing outside the wall or floor for easy connection to the water supply.
Cold water supply
Connect the ice maker to a cold water line with water pressure between 30 and 120 PSI. If you have any questions about your water pressure, call your utility company.
IMPORTANT:
◊In homes with a Reverse Osmosis water treatment system, remove the water inlet connector from the “yellow” valve and attached to the “blue” valve. Make sure the water filter bypass plug is in place.
Model |
|
41 1/2”” (1054mm) | |
47 1/2”” (1207mm) |