7.Remove the four #15 Torx plastic collar screws from the fountain/escutcheon collar.
insTallaTion insTRuCTions
Terminals
Control Panel
7
8.Place the fountain/ escutcheon collar onto the backer panel. Use tape to hold in place.
9.Open the freezer door and slide panel onto the door.
10.The holes in the fountain/escutcheon collar should line up with the mounting holes in the door panel. Reverse instructions 7 to 1 (ex. Replace the four #15 Torx plastic collar screws from the fountain escutcheon collar)
8 |
9 |
10
Stainless Steel
Splashguard
Spill Tray Grille
CAUTION
WARNING – Do not exceed the panel dimensions shown in the chart on page 4 for the grille panel. If the decorator panel is larger than specified, it may restrict the airflow to the compressor and condenser area, which may cause the unit to function improperly.
IMPORTANT: When attaching a raised wood panel of 1/2” or thicker secure the raised panel to the back of the grille cover frame. Use 4 #8 or similar screws.
Adjust Door Hinges
Check to make sure the doors are properly aligned. If not, the door hinges will have to be adjusted. Remove the two small shipping screws from the top and bottom hinge as shown below. Next, using a #25 torx screwdriver, loosen the torx head screws in the top and bottom hinge. Loosen the torx head screws only slightly, so that the door will remain in position as you adjust it. You will now be able to move the door to the left or right. Once the adjustments are made, tighten the torx head screws - do not put the shipping screws back.