Dacor 100500 manual Anchoring the Unit, Side Panel Installation

Page 15

Installation Instructions

Side Panel Installation

If using side panels with the Dacor® Built-In Refrigerator, they will need to be 1/4-inch thick. Slide the panel into position and secure with screws indicated by the shaded area. A 3/16-inch spacer is required between the cabinet and side panel. A 1/2-inch thick by 10 1/4- inch tall spacer is required if the side panel extends up into the machine compartment area on the refrigerator side.

1/4" side panel fitted up to the cabinet trim (top view) on Freezer side.

Backside of Unit

#8-32 1/2"

Screw

3/16" (5mm) Spacers

1/4" (6mm) Side Panel

Freezer Side of Unit

Door

1/4" side panel fitted up to the cabinet trim (top view) on Refrigerator side.

Backside of Unit

#8-32 1/2" Screw

1/2" (13mm) Spacers on side of machine compartment

[3/16" (5mm) below the machine compartment]

1/4" (6mm) Side Panel

Refrigerator Side of Unit

Door

Drill 3 holes through vertical frame into cabinetry where applicable. (approx. location)

Anchoring the Unit

After the door and side panels have been installed, and the unit has been leveled and door adjustment has been completed, you may anchor the unit to the opening.

◊First, make sure the unit has been leveled and aligned, and the doors are adjusted.

◊Drill three 3/16” holes through both outer trims.

◊Drill a 1/8” pilot hole into the cabinetry.

◊Install screws.

13

Page 14 Page 16
Image 15
Page 14 Page 16
Contents
Install ation Instructions Built-In Refriger ators Page Table of Contents Refrigerator SafetyInstallation Recommendations Design Specifications Product DimensionsDoor Swing Dimensions Custom Overlay Panels Overlay Panel Specifications See Illustrations on Side Panel SpecificationsModel Hole ADia Hole BDia Overall Length C Custom Toe Kickplate SpecificationsCustom Handle Specifications Custom Panel Door Swing SpecificationsDoor Stop Installation Specifications Tools and PartsLocation Requirements Model Rough-In Width a Electrical RequirementsWater Supply Requirements Cold water supply Blocking the Refrigerator Installation Instructions Unpack Refrigerator Anti-Tip BlockingMove Unit to Final Position Water Line ConnectionPlug in Refrigerator Level UnitRefer to numbered illustrations for steps Install Custom PanelsPanel Installation Panel Installation for Dispenser ModelsAdjust Door Hinges Anchoring the Unit Side Panel InstallationInstallation Checklist Service InformationPage Page Page Web Site Phone 800
Top Page Image Contents