Danby DDW1805W Filtering System, Caring for the Dishwasher, Forget to Add a Dish?

Cancelling or modifying a wash cycle setting. . .

A cycle that is underway can only be modified if it has only been running for a short time. Otherwise, the detergent may have already been released, and the appliance may have already drained the wash water. If this is the case, the detergent dispenser must be refilled (see the paragraph entitled " Loading the Detergent " ).

Press the ON/OFF button, and the ON light will turn off. Rotate the dial in the clockwise direction to the desired cycle setting (see the section entitled " Starting a wash cycle. . . " ). Then, turn the dishwasher back on using the ON/OFF button.

At the End of the Wash Cycle

STOP

STOP

When the dial stops turning and is aligned with the STOP mark(see figure), the cycle has finished. Turn off the appliance using the ON/OFF button, shut off the water supply and open the door of the dishwasher. Wait a few minutes before unloading the dishwasher to avoid handling the dishes and utensils while they are still hot and more susceptible to breakage.

STOP

Forget to Add a Dish?

A forgotten dish can be added any time before the detergent cup opens.

1Pull the door handle.

2Do not open the door until the water spray action stops. Steam may rise out of the dishwasher.

3Add forgotten dishes.

4Push the door to close . When the door is properly closed, a click will sound.

FILTERING SYSTEM

For your convenience, we have placed the drain pump and filtering system within easy reach inside the tub. There are three components of the filtering system: the main filter, the coarse filter, and the fine filter.

1Main filter

Food and soil particles trapped by this filter are pulverized by a special jet on the lower spray arm and washed down the drain.

1	2	2	Coarse filter
			Larger items, such as pieces of bone or glass, that could clog the drain are trapped in the

coarse filter. To remove an item caught in this filter, gently squeeze the tabs on top of this filter and lift it out.

33 Fine filter

This filter holds soil and food residue in the sump area and prevents it from being redeposited on the dishes during a cycle.

CARING FOR THE DISHWASHER

To clean the control panel use a lightly dampened cloth then dry thoroughly. To clean the exterior use a good appliance polish wax.

Never use sharp objects, scouring pads or harsh cleaners on any part of the dishwasher.

Protect Against Freezing

If your dishwasher is left in an unheated place during the winter, ask a service technician to:

Safety Instructions

Operating Instructions

Troubleshooting Tips

1Cut off electrical power to the dishwasher and remove fuses or trip circuit breaker.

2Turn off the water supply and disconnect the water inlet pipe from the water valve.

3Drain the water from the inlet pipe and water valve. (Use a pan to catch the water.)

4Reconnect the water inlet pipe to the water valve.

5Remove the plastic sump cover in the tub the bottom and use a sponge to soak up the water in rubber boot.

8