Whirlpool WRS325FDAM, ED2KVEXVB, WRS325FDAW, WRS322FDAM Connect to Refrigerator Style

Page 9

4.Determine the length of copper tubing you need. Measure from the connection on the lower rear corner of refrigerator to the water pipe. Add 7 ft (2.1 m) to allow for cleaning. Use ¹⁄₄" (6.35 mm) O.D. (outside diameter) copper tubing. Be sure both ends of copper tubing are cut square.

5.Using a cordless drill, drill a ¹⁄₄" (6.35 mm) hole in the cold water pipe you have selected.

 

A

G

B

 

 

C

F E

D

A. Cold water pipe

E. Compression sleeve

B. Pipe clamp

F. Shutoff valve

C. Copper tubing

G. Packing nut

D. Compression nut

 

6.Fasten the shutoff valve to the cold water pipe with the pipe clamp. Be sure the outlet end is solidly in the ¹⁄₄" (6.35 mm) drilled hole in the water pipe and that the washer is under the pipe clamp. Tighten the packing nut. Tighten the pipe clamp screws slowly and evenly so the washer makes a watertight seal. Do not overtighten, or you may crush the copper tubing.

7.Slip the compression sleeve and compression nut on the copper tubing as shown. Insert the end of the tubing into the outlet end squarely as far as it will go. Screw the compression nut onto outlet end with adjustable wrench. Do not overtighten.

8.Place the free end of the tubing in a container or sink, and turn ON the main water supply. Flush the tubing until water is clear. Turn OFF the shutoff valve on the water pipe. Coil the copper tubing.

Connect to Refrigerator

Style 1

1.Unplug refrigerator or disconnect power.

2.Remove and discard the short, black plastic part from the end of the water line inlet.

3.Thread the nut onto the end of the tubing. Tighten the nut by hand. Then tighten it with a wrench two more turns. Do not overtighten.

NOTE: To avoid rattling, be sure the copper tubing does not touch the cabinet’s side wall or other parts inside the cabinet.

Style 2

1.Unplug refrigerator or disconnect power.

2.Remove and discard the plastic part that is attached to the inlet of the water valve.

3.Attach the copper tube to the valve inlet using a compression nut and sleeve as shown. Tighten the compression nut. Do not overtighten.

4.Use the tube clamp on the back of the refrigerator to secure the tubing to the refrigerator as shown. This will help avoid damage to the tubing when the refrigerator is pushed back against the wall.

5.Turn shutoff valve ON.

6.Check for leaks. Tighten any connections (including connections at the valve) or nuts that leak.

 

A

 

B

 

C

 

D

 

E

A. Tube clamp

D. Compression nut

B. Tube clamp screw

E. Valve inlet

C. Copper tubing

 

7.On some models, the ice maker is equipped with a built-in water strainer. If your water conditions require a second water strainer, install it in the ¹⁄₄" (6.35 mm) water line at either tube connection. Obtain a water strainer from your nearest appliance dealer.

Style 3

1.Unplug refrigerator or disconnect power.

2.Remove and discard the black nylon plug from the gray water tube on the rear of the refrigerator.

3.If the gray water tube supplied with the refrigerator is not long enough, a ¹⁄₄" x ¹⁄₄" (6.35 mm x 6.35 mm) coupling is needed in order to connect the water tubing to an existing household water line. Thread the provided nut onto the coupling on the end of the copper tubing.

NOTE: Tighten the nut by hand. Then tighten it with a wrench two more turns. Do not overtighten.

A

B

C

D

 

A. Household water line

C. Ferrule (purchased)

 

B. Nut (purchased)

 

D. Refrigerator water tubing

4.Install the water supply tube clamp around the water supply line to reduce strain on the coupling.

5.Turn shutoff valve ON.

6.Check for leaks. Tighten any connections (including connections at the valve) or nuts that leak.

A

B

C

D

E F G

A. Refrigerator water tubing

 

E. Ferrule (purchased)

B. Nut (provided)

 

 

F. Nut (purchased)

C. Bulb

 

 

 

G. Household water line

D. Coupling (purchased)

 

 

4.Turn shutoff valve ON.

5.Check for leaks. Tighten any nuts or connections (including connections at the valve) that leak.

9

Page 8 Page 10
Image 9
Page 8 Page 10
Contents Refrigerator User Instructions Your safety and the safety of others are very important Refrigerator SafetyInstallation Instructions Unpack the RefrigeratorBefore You Throw Away Your Old Refrigerator or Freezer Tools Needed Door Removal, Leveling and AlignmentRemove the Doors Replace the Doors and HingesLeveling and Door Closing To Install the Handles Handle Installation and RemovalDoor Alignment To Remove the HandlesElectrical Requirements Location RequirementsWater Supply Requirements Recommended Grounding MethodConnect Water Supply Connect to Refrigerator Style Refrigerator USE Using the ControlsCrisper Humidity Control Water and Ice DispensersTo Dispense Water Water DispenserTo Dispense Ice Dispenser LightWater Filtration System Ice Maker and Storage BinNon-Indicator Water Filter on some models CleaningTo Clean Your Refrigerator Refrigerator CareVacation and Moving Care LightsVacations MovingProblem Solver Possible Causes and/or Recommended SolutionsGeneral Operation Interior moisture buildup Temperature is too warmDispenser lights Do not workICE and Water Doors and LevelingWill not operate Ice dispenserProperly Ice or water has anWater Filter Certifications AccessoriesWater Filtration System Performance Data SheetLimited Warranty Whirlpool Corporation Major Appliance WarrantyItems Excluded from Warranty This limited warranty does not coverSeguridad DEL Refrigerador Instrucciones Para EL Usuario DEL RefrigeradorInstrucciones DE Instalación Desempaque el refrigeradorAntes de tirar su viejo refrigerador o congelador Herramientas Necesarias Remoción, nivelación y alineamiento de las puertasVuelva a colocar las puertas y las bisagras Quite las puertasNivelación y cierre de las puertas Cómo instalar y remover las manijasAlineamiento de las puertas Para instalar las manijasRequisitos eléctricos Requisitos de ubicaciónPara quitar las manijas Método de conexión a tierra recomendadoConexión del suministro de agua Requisitos del suministro de aguaConexión al refrigerador Estilo EstiloUSO DE SU Refrigerador Uso de los controlesCómo terminar la instalación Despachadores de agua y hielo Control de humedad del Cajón para verdurasEl despachador de hielo Fábrica de hielo y depósitoPara despachar hielo La luz del despachadorSistema de filtración de agua Limpieza Cuidado DE SU RefrigeradorLuces Para limpiar su refrigeradorVacaciones Cuidado durante las vacaciones y mudanzasMudanza Si Ud. decide apagar el refrigerador antes de irseFuncionamiento Solución DE ProblemasCausas posibles y/o soluciones recomendadas EN GeneralParece ruidoso El refrigeradorLos ruidos que se indican a continuación son normales La temperatura estáLas luces del Puertas Y NivelaciónDespachador En algunos modelosHielo Y Agua El despachador de Hielo no funcionaDebidamente Conducto de hielo esté libre de escarcha o pedazos de hielo AccesoriosLimpiador de acero inoxidable affresh Limpiador para cocina y electrodomésticos affreshSistema de filtración de agua Hoja DE Datos DEL RendimientoExclusiones DE LA Garantía Garantía LimitadaEsta garantía limitada no cubre Exclusión DE Garantías ImplícitasWhirlpool Brand Home Appliances Sécurité DU Réfrigérateur Instructions Dutilisation DU RéfrigérateurInstructions Dinstallation Déballage du réfrigérateurAvant de jeter votre vieux réfrigérateur ou congélateur Outillage Nécessaire Retrait, réglage de laplomb et alignement des portesEnlever les portes Réinstaller les portes et les charnièresInstallation des poignées Installation et démontage des poignéesNivellement et fermeture des portes Alignement des portesMéthode recommandée de mise à la terre Exigences demplacementSpécifications électriques Retrait des poignéesRaccordement de la canalisation deau Spécifications de l’alimentation en eauRenflement Raccordement au réfrigérateur Style Achever l’installationUtilisation DU Réfrigérateur Utilisation des commandesRéglage de lhumidité dans le bac à Légumes Distributeurs deau et de glaçonsDistribution d’eau Le distributeur deauLe distributeur de glaçons Distribution de glaçonsMachine à glaçons et bac Dentreposage Pour retirer et réinstaller le bac à glaçonsSystème de filtration de leau Le verrouillage du distributeurNettoyage Entretien DU RéfrigérateurFiltre à eau sans indicateur lumineux sur certains modèles Changer le filtre à eauEntretien avant les vacances ou Lors d’un déménagement LampesVacances DéménagementRésolution DE Problèmes Causes possibles et/ou solutions recommandéesUtilisation Générale Semble bruyant Le réfrigérateurLes bruits suivants sont normaux La températurePortes ET Nivellement Les lampes du distributeurSur certains modèles Glaçons ET EAU Le distributeur de Glaçons ne fonctionnePas correctement Accessoires Système de filtration d’eau Feuille DE Données SUR LA PerformanceGarantie Limitée Garantie DE Gros Appareil Ménager Whirlpool CorporationÉléments Exclus DE LA Garantie La présente garantie limitée ne couvre pasPage Whirlpool. Used under license in Canada. All rights reserved

WRS322FDAM, WRS325FDAW, WRS325FDAM, ED2KVEXVB specifications

Whirlpool has established a strong reputation in the home appliance market, particularly known for its innovative and reliable refrigerators. This article explores a selection of Whirlpool refrigerator models: ED2KVEXVB, WRS325FDAM, WRS325FDAW, and WRS322FDAM, highlighting their main features, technologies, and characteristics.

The Whirlpool ED2KVEXVB is a top freezer refrigerator that combines classic design with modern functionality. One of its standout features is the Adaptive Defrost system, which optimizes the defrost process based on the usage patterns of the refrigerator. This not only helps in maintaining an even temperature but also improves energy efficiency. The ED2KVEXVB also offers a convenient spill-proof glass shelf design, which helps contain spills and prevents the mess from spreading to other areas.

Moving on to the WRS325FDAM and WRS325FDAW, these side-by-side models bring convenience and organization to your kitchen. Both models feature a sleek finish and an external water and ice dispenser, allowing you to access refreshing drinks at the touch of a button. The Accu-Chill temperature management system ensures that foods stay fresh longer by adapting the cooling based on the conditions in the refrigerator. Additionally, these models come with humidity-controlled crisper drawers that help to keep produce fresher.

The WRS322FDAM shares many of the features of the WRS325FDAM and WRS325FDAW, further emphasizing Whirlpool's commitment to consumer needs. This model also provides an exterior ice and water dispenser and incorporates the same Accu-Chill technology. Moreover, the additional IntelliSense technology monitors the internal temperature and makes adjustments accordingly, ensuring optimal working conditions.

All four models are designed with energy efficiency in mind, boasting Energy Star certification, which signifies lower energy consumption, ultimately leading to cost savings on utility bills. They also feature adjustable shelves, allowing users to customize the interior layout according to their needs.

In summary, Whirlpool's ED2KVEXVB, WRS325FDAM, WRS325FDAW, and WRS322FDAM models represent a range of features aimed at improving user experience. With efficient cooling technologies, customizable interior layouts, and energy-efficient designs, these refrigerators stand out in the crowded appliance market, delivering reliability and innovation for modern homes.
Top Page Image Contents