Whirlpool ET16JMXL warranty Removing the light Shield, Removing the Crispers and Crisper Covers

,Push In the Center; Pull Dawn

Push the lab to Clear the Cover

Removing the light Shield.

You may want to remove the light shield when cleaning, or for changing the bulb. First, unplug the refrigerator. Then, push lightly on the upper center of the shield until the notched tab is free from the console. Pull down until the tab clears, then lift the back hooks out of their slots.

To replace it, do the reverse.

Removing the Crispers and Crisper Covers.

To remove the crispers, slide them out until they stop. Lift the front a little and slide them the rest of the way out.

Each cover is held in place by two pegs at the back and two notched tabs in the front. Press the tabs out of the way to lift the front. Lift the back off the pegs.

To put the covers back, replace the center leg. Replace each cover by first fitting the back notches over the pegs. Then push the front down into the notched tabs.

The center leg can be made shorter or longer to help level the crisper covers, if necessary. Turn the leg clockwise to make it longer.

Turn it counter-clockwise to shorten it.

ICE MAGIC”

Automatic

Ice

Maker.

There is a wire signal arm below the ice maker. [It hangs in the bin

when the bin is empty.) When the bin is full, the ice cubes lift up the

arm and the ice maker shuts off

Snap Back Into Place

There is an ON /OFF switch on the ice maker. When you remove the

bin,

be

sure

you

move

the

switch to

OFF. This will

stop

the

ice

maker

from

dumping

any ice until you put

the

bin

back. Move

the

switch

back

to ON

when

you

put

the

bin

back.

Shake

the

bin

occasionally

to

keep

cubes

separated

and

to

spread them out so the bin will hold more.

You will hear water running when the ice maker is working. You’ll

also hear ice fall into the bin. Don’t let these new sounds bother

you.

Because

of

new

plumbing

connections,

the

first batch

ortwo

of

ice

may

be

discolored

or off flavored.

The

ice

maker

will

not

operate

until

the

freezer

is cold

enough

to

make ice. This can

take

overnight

after you

start

the

refrigerator

for

the

first

time.

Your ice maker will work faster when the freezer is colder. If you

want

more

ice,

turn the

Temperature

Control dial to a higher num-

ber, or turn the Air Control dial toward A.

If cubes

are

stored

too

long,

they

may

develop

an

off-flavorrlike

stale

water.

Throw

them

away.

They

will

be

replaced.

Cubes

in the

ice

bin

can

also become

smaller

by evaporation,