Using and maintaining
special model features. | Model RS25AW |
| Continued |
E. Removing and emptying the ice storage bin.
Remove the ice maker storage bin if:
-ice dispenser has not or will not be used for a week.
-a power failure causes ice to melt and freeze together.
-ice dispenser is not used regularly.
1.Lift covering panel up from the bottom and slide it back to the rear.
2.Lift the ice maker signal arm until it clicks into the OFF position. Ice can be dispensed, but no more will be made.
3.Lift the front of the storage bin and
pull the bin out.
4.Empty the bin. Use hot or warm water to melt any remaining ice.
Do Not use sharp objects to break up ice in the bin. This can damage the bin and dispenser mechanism.
5.Wash the bin with mild detergent. Rinse well.
Do Not use harsh or abrasive cleansers or solvents.
6.Slide the bin back into place. Make sure it is pushed in all the way.
7.Lower the signal arm to the ON position to restart ice production.
F.Automatic Ice maker.
For use and care information, see Page 6.
G. Changing ice dispenser light bulb.
1.Remove the bulb from the socket inside the dispenser area.
2.Replace bulb with a
Cold water and ice dispenser tips.
. Use only ice crescents from the ice maker. Other shapes will not dispense properly.
.
.
.
Large amounts of ice (more than two glasses) should be taken from the ice maker storage bin not the dispenser. The dispenser motor may stop if the dispenser bar is held in too long. If the motor stops, it will restart in about 3 minutes.
Cubes left in the bin for long periods of time may develop an
Good water quality is important for good ice quality. It is not recommended that you connect the ice maker to a softened water supply. If a softened water supply cannot be avoided, it is important to maintain the water softener so it operates properly. Water softener chemicals, such as salt from a malfunctioning softener, can damage the ice maker mold and lead to poor quality ice.
Before you call for service for your cold water and ice dispenser...
If you are having an operating problem, check this chart to see what might be the cause before you call for assistance.
Operating problem
Cold water and ice dispenser will not work.
Ice dispenser will not work.
Ice dispenser stops working.
Check if
Freezer door is open.
Ice storage bin is pushed in all the way.
Old ice has clumped together.
Ice dispenser bar is held in too long.
Airborne odors are near ice. Ice is old.
Water quality is good.
Foods are properly wrapped.
Ice bin and freezer are clean.
Ice maker is properly plumbed.
New ice maker.
What to do
Close the freezer door.
Push bin in all the way.
Use only ice crescents from ice maker. Other shapes won’t dispense properly.
Throw away old ice and make new.
Wait about 3 minutes for dispenser motor to reset. Large amounts of ice should be taken from the bin, not through the dispenser.
Use ice immediately or store in covered container. Throw away old ice and make new.
Water containing minerals (such as sulfur) may require a filter.
Store frozen foods in packages or containers that provide a good seal against moisture and air.
Clean ice storage bin and freezer. Directions are on Pages 8 & 9.
Properly hook up ice maker water supply. See Installation Instructions.
Note: First ice may be discolored or
Page 8