Before using your refrigerator-freezer...
A. Removethe energy and
sales information labels...
by lifting one edge of each label and pulling straight off. Use a damp cloth to take off any glue residue. Remove all shipping tape.
a Do Not use any sharp instruments or any harsh, abrasive cleansers.
. Do Not use rubbing alcohol or flammable toxic solvents such as acetone, gasoline, carbon tetrachloride, etc.
. Do Not remove any permanent instruction labels inside the refrigerator.
. Do Not remove the Tech Sheet.
B. Clean the refrigerator ...
inside and out before plugging it into an outlet. Cleaning instructions are given on Page 9.
D. Install the refrigerator ...
according to the dimensions shown. Leave extra space along the hingerside walls to allow the doors to be opened wider. Make sure ice maker water supply line has been connected.
Do Not install the refrigerator:
Inext to an oven, radiator or other heat source;
I out in the weather or direct sunlight;
nin an area where the room temperature will fall below 55°F
(13°C).
Leave l/2” (1.25 cm) at the top and each side of the refrigerator for easier installation.
1l-l
E. Level the refrigerator.
Use screwdriver
Rlght to raise; left to lower
Do Not use an outlet that can be turned off with a switch or pull chain.
C. Plug the refrigerator ...
into a
.
ti
Refrigerator can be installed flush against back wall.
Make sure the refrigerator is level for efficient operation.
1.Remove base grille (see Page 5).
2.Place a level on top of the refrigerator - first side to side then front to back. Turn each leveling screw to the right to raise the front of the refrigerator. Turn each leveling screw to the left to
lower the front of the refrigerator.
3.Check the levelness again and repeat Step 2 until the refrigerator is level.
4.Replace base grille.
Page 3