Whirlpool GB2SHKLLS00 manual Connecting to Refrigerator, Removing the Base Grille

Page 6

4.To determine the length of copper tubing you will need, measure from connection on lower left rear of refrigerator to water pipe. Add 7 ft. (2.1 m) to allow for moving refrigerator for cleaning. Use ¹⁄₄ in. (6.35 mm) O.D. (outside diameter) copper tubing. Be sure both ends of copper tubing are cut square.

5.Use a hammer and center punch to mark drilling location on water pipe. Using a grounded drill, drill a ¹⁄₄ in. hole in the cold water pipe you have selected.

 

 

 

1

 

 

 

2

 

 

 

3

 

 

 

4

 

 

 

5

 

 

 

6

 

 

 

7

1.

Cold Water Pipe

5.

Compression Sleeve

2.

Pipe Clamp

6.

Shutoff Valve

3.

Copper Tubing

7.

Packing Nut

4.Compression Nut

6.Fasten shutoff valve to cold water pipe with pipe clamp. Be sure outlet end is solidly in the ¹⁄₄ in. drilled hole in the water pipe and that rubber washer is under the pipe clamp. Tighten packing nut. Tighten the pipe clamp screws carefully and evenly so rubber washer makes a watertight seal. Do not overtighten or you may crush the copper tubing, especially if soft (coiled) copper tubing is used. Now you are ready to connect the copper tubing.

7.Slip compression sleeve and compression nut on copper tubing as shown. Insert end of tubing into outlet end squarely as far as it will go. Screw compression nut onto outlet end with adjustable wrench. Do not overtighten.

8.Place the free end of the tubing into a bucket or sink. Turn ON main water supply and flush out tubing until water is clear. Turn OFF shutoff valve on the water pipe. Check for leaks. Coil copper tubing.

Connecting to Refrigerator

1.Remove plastic cap from water valve inlet port. Attach the copper tube to the valve inlet using a compression nut and sleeve as shown. Tighten the compression nut. Do not overtighten. Confirm copper tubing is secure by pulling on copper tubing.

2.Create a service loop using extreme care to avoid kinks. Secure copper tubing to refrigerator cabinet with a “P” clamp.

1

2

3

4

5

1.Copper Tubing

2.“P” Clamp

3.Compression Nut

4.Compression Sleeve

5.Water Valve Inlet Port

3.Turn on water supply to refrigerator and check for leaks. Correct any leaks.

4.Plug in refrigerator or reconnect power.

5.Push refrigerator into opening.

Base Grille

Removing the Base Grille

1.Open the freezer door.

2.Grasp the grille with both hands.

3.Pull up on the bottom and tilt it toward you.

4.Pull down to release the top of grille.

Replacing the Base Grille

1.Open the freezer door.

2.See markings on inside of base grille for proper placement.

3.Snap the top of grille into place first.

4.Press down and in on the bottom of the grille until it snaps into place.

6

Page 5 Page 7
Image 6
Page 5 Page 7
Contents Use & Care Guide BOTTOM-MOUNT RefrigeratorRéfrigérateur Superposé Guide d’utilisation Etd’entretienTable DES Matières Refrigerator Safety Before you throw away your old refrigerator or freezerUnpacking Refrigerator InstallationCleaning before use Location RequirementsFor Automatic Ice Maker Accessory Electrical RequirementsWater Supply Connection Removing the Base Grille Connecting to RefrigeratorBase Grille Replacing the Base GrilleRefrigerator Doors Door Removal Replacement Normal Sounds Refrigerator USEDoor Closing and Alignment Ensuring Proper Air CirculationIce Maker Using the ControlsAdjusting Control Settings Turning the Ice Maker On/OffMeat Drawer and Cover Refrigerator FeaturesRefrigerator Shelves Crisper and Crisper CoverFreezer Features Door Features Refrigerator CareVacation and Moving Care Power InterruptionsChanging the Light Bulb Changing the Refrigerator Light BulbTroubleshooting Ice maker is not producing ice on some models Temperature is too warmRefrigerator seems to make too much noise Ice maker is producing too little ice on some modelsCanada AccessoriesU.S.A For some modelsWhirlpool Corporation will not pay for CallSécurité DU Réfrigérateur Avant de jeter votre vieux réfrigérateur ou congélateurDéballage Installation DU RéfrigérateurEmplacement d’installation Nettoyage avant l’utilisationSpécifications électriques Raccordement de la canalisation d’eauPour appareils avec machines à glaçons automatiques Pour enlever la grille de la base Grille de la baseRaccordement au réfrigérateur Pour replacer la grille de la basePortes du réfrigérateur Installation et enlèvement des poignées de porteRéinstallation Portes et charnières Enlèvement des portes et des charnièresÉtapes finales Inspecter tous les trous. Vérifier que tous les bouchonsFermeture et alignement des portes Sons normauxFermeture des portes Utilisation DU Réfrigérateur Ajustement des réglages de commandeUtilisation des commandes Pour s’assurer d’une circulation d’air AppropriéeMise en marche/arrêt de la machine à glaçons Machine à glaçonsTablettes du réfrigérateur Augmentation du taux de production de glaçonsBac à légumes et couvercle Sur certains modèles AccessoireTiroir à viande et couvercle Réglage de l’humiditédans les bacs àlégumesCongélateur LA Porte Entretien DU RéfrigérateurRemplacement de l’ampoule d’éclairage Remplacement de lampoule du compartiment de réfrigérationRemplacement de lampoule du compartiment de congélation Vacances Pannes de courantDéménagement DéménagementLe plat de dégivrage contient de l’eau DépannageLes ampoules n’éclairent pas Le moteur semble fonctionner excessivementIl existe une accumulation d’humidité à l’intérieur La cloison entre les deux sections est tièdeLa température est trop tiède Les portes sont difficiles à ouvrirAssistance OU Service AccessoiresPour certains modèles Whirlpool Corporation ne paiera pas pour 12642707SP/2225034A

GB2SHKLLS00 specifications

The Whirlpool GB2SHKLLS00 is a renowned side-by-side refrigerator that embodies modern convenience and efficiency. With its sleek stainless steel design, this appliance not only complements your kitchen aesthetics but also delivers functionality that meets everyday needs.

One of the standout features of the GB2SHKLLS00 is its ample storage capacity. With a total volume that caters to families of various sizes, it offers generous shelving options and adjustable door bins that provide flexibility for organizing groceries. The refrigerator section boasts crisp drawers designed to keep fruits and vegetables fresh while preventing moisture loss. Meanwhile, the ice and water dispenser conveniently located on the door allows easy access to chilled water and ice without opening the appliance, helping to maintain internal temperatures.

The technology incorporated into the GB2SHKLLS00 enhances user experience significantly. The Accu-Chill Temperature Management System ensures that food stays fresher for longer by effectively managing internal temperatures based on usage patterns. This is complemented by the Adaptive Defrost system, which monitors when the refrigerator is in use and defrosts only when necessary, contributing to energy efficiency.

Energy efficiency remains a crucial consideration, and Whirlpool addresses this with the GB2SHKLLS00 by incorporating eco-friendly technologies. It comes with an Energy Star rating, which signifies its ability to reduce energy consumption without compromising performance. This feature not only saves on electricity bills but also promotes a more sustainable lifestyle.

In addition to practical features, the Whirlpool GB2SHKLLS00 is designed for user convenience. The exterior is easy to clean, preventing fingerprint smudges and allowing for a maintained polished look. Furthermore, the LED lighting inside illuminates every corner of the appliance, providing better visibility without using excessive energy.

Overall, the Whirlpool GB2SHKLLS00 is a harmonized blend of functional design, advanced technology, and energy efficiency. Whether you're passionate about cooking or simply need a reliable refrigerator to keep your family’s food fresh, this model stands out as a dependable choice in the market. With its array of features tailored to modern living, it fosters an organized kitchen environment that caters to the needs of busy households.
Top Page Image Contents