Whirlpool W10316634A LocationRequirements, Electrical Requirements, Recommended Grounding Method

Page 3

LocationRequirements

WARNING

Explosion Hazard

Keep flammable materials and vapors, such as gasoline, away from refrigerator.

Failure to do so can result in death, explosion, or fire.

To ensure proper ventilation for your refrigerator, allow for ¹⁄₂" (1.25 cm) of space on each side and at the top. Allow for 1"

(2.54 cm) of space behind the refrigerator. If your refrigerator has an ice maker, allow extra space at the back for the water line connections. When installing your refrigerator next to a fixed wall, leave a 2" (5.08 cm) minimum space on each side (depending on your model) to allow the doors to swing open.

1/2" (1.25 cm)

2" (5.08 cm)

NOTES:

■It is recommended that you do not install the refrigerator near an oven, radiator, or other heat source. Do not install in a location where the temperature will fall below 55°F (13°C).

■Normal minimum cabinet cut-out width required for product installation is 36" (91.44 cm). However, if the product is placed against an extended wall and the ability to remove the crisper pans is desired, an additional 18" (45.72 cm) of cabinet width is required, so a total cabinet opening width of 54"

(137.16 cm) is recommended.

Electrical Requirements

WARNING

Electrical Shock Hazard

Plug into a grounded 3 prong outlet.

Do not remove ground prong.

Do not use an adapter.

Do not use an extension cord.

Failure to follow these instructions can result in death, fire, or electrical shock.

Before you move your refrigerator into its final location, it is important to make sure you have the proper electrical connection.

Recommended Grounding Method

A 115 Volt, 60 Hz., AC only, 15- or 20-amp fused, grounded electrical supply is required. It is recommended that a separate circuit serving only your refrigerator be provided. Use an outlet that cannot be turned off by a switch. Do not use an extension cord.

NOTE: Before performing any type of installation, cleaning, or removing a light bulb, turn the control (Thermostat, Refrigerator or Freezer Control depending on the model) to OFF and then disconnect the refrigerator from the electrical source. When you are finished, reconnect the refrigerator to the electrical source and reset the control (Thermostat, Refrigerator or Freezer Control depending on the model) to the desired setting. See “Using the Controls.”

3

Image 3

Contents Refrigerator User Instructions Refrigerator SafetyInstallation Instructions Unpack the RefrigeratorBefore You Throw Away Your Old Refrigerator or Freezer LocationRequirements Electrical RequirementsRecommended Grounding Method Style Water Supply RequirementsConnect Water Supply Reverse Osmosis Water SupplyUsing theControls Refrigerator USEStyle 1 Rotary Controls Style 2 Slide Controls Water and Ice Dispensers ConvertibleDrawer Temperature ControlCrisper Humidity Control Chilled Door BinIce Maker and Storage Bin To Dispense IceRemember Water Filtration System CleaningTo Clean Your Refrigerator Refrigerator CareMotor seems to run too much TroubleshootingChanging the Light Bulbs Refrigerator OperationDoors will not close completely Temperature and MoistureTemperature is too warm Ice and WaterStandard Base Filter Cartridge AccessoriesStainless Steel Cleaner and Polish Dispenser water is not cool enough on some modelsWater Filter Certifications Base Grille Water Filtration System Performance Data SheetsBase Grille Water Filtration System Base Grille Water Filtration System Base Grille Water Filtration System Disclaimer of Implied Warranties Limited WarrantyItems Excluded from Warranty This limited warranty does not coverRéfrigérateur Sécurité DU RéfrigérateurAvant de jeter votre vieux réfrigérateur ou congélateur Instructions DinstallationExigences demplacement Déballagedu réfrigérateurAlimentation en eau par osmose inverse Méthode recommandée de mise à la terreSpécificationsélectriques Spécifications del’alimentationen eauRaccordement de la canalisation deau Raccordement à une canalisation d’eauRaccordement au réfrigérateur Ajustement des commandes Utilisation des commandesAchever l’installation Style 1 Commandes rotatives Style 2 Commandes à glissièreCompartiment froid de la porte Distributeurs deauet de glaçonsCONDITION/RAISON Ajustement Machineà glaçons et bac dentreposage Distribution deauDistribution de glace Utilisation du distributeur sans filtre à eau Pour retirer et réinstaller le bac à glaçonsSystème defiltrationde leau Filtre à eau sans indicateur lumineux sur certains modèlesNettoyage de votre réfrigérateur Remplacement des ampoules d’éclairageEntretien DU Réfrigérateur NettoyageLe moteur semble fonctionner excessivement DépannageFonctionnement du réfrigérateur Le réfrigérateur ne fonctionne pasGlaçons et eau Température et humiditéAccessoires Nettoyant et poli pour acier inoxydableCartouche du filtre de la base standard Système de filtration deau de la grille de la base Feuilles DE Données SUR LA PerformanceSystème de filtration deau de la grille de la base 909 mg/L Mg/L ± 10 % 05 mg/L 97,4 Particules classe 4200 #/mL 1900 #/mL 99,9 La présente garantie limitée ne couvre pas Garantie DE Gros Appareil Ménager Whirlpool CorporationGarantie Limitée Éléments Exclus DE LA GarantiePage Whirlpool Corporation All rights reserved W10316634A SP PN W10316635A