Whirlpool W10316634A ConvertibleDrawer Temperature Control, Crisper Humidity Control

Page 6

Adjusting Controls

Give the refrigerator time to cool down completely before adding food. It is best to wait 24 hours before you put food into the refrigerator. The settings indicated in the previous section should be correct for normal household refrigerator usage. The controls are set correctly when milk or juice is as cold as you like and when ice cream is firm.

Rotary Controls: Turn the control right (clockwise) to make the compartment colder. Turn the control left (counterclockwise) to make it less cold. To turn the cooling system off, turn the Refrigerator Control counterclockwise until it reaches the OFF position.

Slide Controls: Slide the control one setting to the right to make the compartment colder. Slide the control one setting to the left to make it less cold.

If you need to adjust temperatures in the refrigerator or freezer, use the settings listed in the chart below as a guide. Wait at least 24 hours between adjustments.

CONDITION/REASON:

ADJUSTMENT:

 

 

REFRIGERATOR too warm

REFRIGERATOR Control

 

one setting higher

 

 

FREEZER too warm/

FREEZER Control

too little ice

one setting higher

 

 

REFRIGERATOR too cold

REFRIGERATOR Control

 

one setting lower

 

 

FREEZER too cold

FREEZER Control

 

one setting lower

ConvertibleDrawer Temperature Control

(on somemodels)

The control can be adjusted to properly chill meats or vegetables. The air inside the pan is cooled to avoid “spot” freezing and can be set to keep meats at the National Livestock and Meat Board recommended storage temperatures of 28° to 32°F (-2° to 0°C). The convertible vegetable/meat drawer control comes preset at the lowest meat setting.

To store meat:

Set the control to one of the three MEAT settings to store meat at its optimal storage temperature.

To store vegetables:

Set the control to VEG to store vegetables at their optimal storage temperatures.

NOTE: If food starts to freeze, move the control to the left (less cold). Remember to wait 24 hours between adjustments.

Crisper Humidity Control

(on somemodels)

You can control the amount of humidity in the moisture-sealed crisper. Adjust the control to any setting between LOW and HIGH.

LOW (open) for best storage of fruits and vegetables with skins. HIGH (closed) for best storage of fresh, leafy vegetables.

Chilled Door Bin

(on somemodels)

Cool air from the freezer is directed to the refrigerator door bin directly beneath the vents.

NOTE: The dairy compartment and can rack are not associated with the Chilled Door Bin feature.

Chilled Door Bin Control

The chilled door bin control is located on the left-hand side of the refrigerator compartment.

A

A. Chilled door bin control

Slide the door chill control to the left to reduce the flow of cold air to the bin and make it less cold.

Slide the door chill control to the right to increase the flow of cold air to the bin and make it colder.

Water and Ice Dispensers

(on somemodels)

Depending on your model, you may have one or more of the following options: the ability to select either crushed or cubed ice, chilled water, a special light that turns on when you use the dispenser, or a lock option to avoid unintentional dispensing.

IMPORTANT: After connecting the refrigerator to a water source or replacing the water filter, flush the water system. Use a sturdy container to depress and hold the water dispenser lever for

5 seconds, then release it for 5 seconds. Repeat until water begins to flow. Once water begins to flow, continue depressing and releasing the dispenser lever (5 seconds on, 5 seconds off) until a total of 3 gal. (12 L) has been dispensed. This will flush air from the filter and water dispensing system, and prepare the water filter for use. Additional flushing may be required in some households. As air is cleared from the system, water may spurt out of the dispenser.

NOTES:

The dispensing system will not operate when the freezer door is open.

On some models: Allow 24 hours for the refrigerator to cool down and chill water.

Allow 24 hours to produce the first batch of ice. Discard the first three batches of ice produced.

The Water Dispenser

IMPORTANT: Dispense enough water every week to maintain a fresh supply.

To Dispense Water:

1.Press a sturdy glass against the water dispenser lever.

2.Remove the glass to stop dispensing.

6

Image 6
Contents Refrigerator Safety Refrigerator User InstructionsInstallation Instructions Unpack the RefrigeratorBefore You Throw Away Your Old Refrigerator or Freezer LocationRequirements Electrical RequirementsRecommended Grounding Method Reverse Osmosis Water Supply Water Supply RequirementsConnect Water Supply StyleUsing theControls Refrigerator USEStyle 1 Rotary Controls Style 2 Slide Controls Chilled Door Bin ConvertibleDrawer Temperature ControlCrisper Humidity Control Water and Ice DispensersIce Maker and Storage Bin To Dispense IceRemember Refrigerator Care CleaningTo Clean Your Refrigerator Water Filtration SystemRefrigerator Operation TroubleshootingChanging the Light Bulbs Motor seems to run too muchIce and Water Temperature and MoistureTemperature is too warm Doors will not close completelyDispenser water is not cool enough on some models AccessoriesStainless Steel Cleaner and Polish Standard Base Filter CartridgeWater Filter Certifications Performance Data Sheets Base Grille Water Filtration SystemBase Grille Water Filtration System Base Grille Water Filtration System Base Grille Water Filtration System This limited warranty does not cover Limited WarrantyItems Excluded from Warranty Disclaimer of Implied WarrantiesSécurité DU Réfrigérateur RéfrigérateurDéballagedu réfrigérateur Instructions DinstallationExigences demplacement Avant de jeter votre vieux réfrigérateur ou congélateurSpécifications del’alimentationen eau Méthode recommandée de mise à la terreSpécificationsélectriques Alimentation en eau par osmose inverseRaccordement de la canalisation deau Raccordement à une canalisation d’eauRaccordement au réfrigérateur Style 1 Commandes rotatives Style 2 Commandes à glissière Utilisation des commandesAchever l’installation Ajustement des commandesCompartiment froid de la porte Distributeurs deauet de glaçonsCONDITION/RAISON Ajustement Machineà glaçons et bac dentreposage Distribution deauDistribution de glace Filtre à eau sans indicateur lumineux sur certains modèles Pour retirer et réinstaller le bac à glaçonsSystème defiltrationde leau Utilisation du distributeur sans filtre à eauNettoyage Remplacement des ampoules d’éclairageEntretien DU Réfrigérateur Nettoyage de votre réfrigérateurLe réfrigérateur ne fonctionne pas DépannageFonctionnement du réfrigérateur Le moteur semble fonctionner excessivementTempérature et humidité Glaçons et eauAccessoires Nettoyant et poli pour acier inoxydableCartouche du filtre de la base standard Feuilles DE Données SUR LA Performance Système de filtration deau de la grille de la baseSystème de filtration deau de la grille de la base 909 mg/L Mg/L ± 10 % 05 mg/L 97,4 Particules classe 4200 #/mL 1900 #/mL 99,9 Éléments Exclus DE LA Garantie Garantie DE Gros Appareil Ménager Whirlpool CorporationGarantie Limitée La présente garantie limitée ne couvre pasPage W10316634A SP PN W10316635A Whirlpool Corporation All rights reserved