Whirlpool W10215185A Refrigerator Doors and Drawer, Connect to Refrigerator, To Replace Handles

Page 5

Connect to Refrigerator

1.Remove plastic cap from water supply connection. Place brass nut and compression sleeve on copper tube end as shown.

A

B

A. Brass nut

B. Compression sleeve

2.Place end of copper tubing into plastic water valve supply line. Slide the brass nut over the sleeve and screw the nut into supply line.

3.Using an adjustable wrench, hold the nut on the plastic water line to keep it from moving. Then, with a second wrench turn the nut on the copper tubing counterclockwise to completely tighten. Do not overtighten.

4.Check connection by pulling on the copper tubing.

5.Attach the copper tubing to the refrigerator with a “P” clamp. Slide the plastic water line into the retainer.

A

B

C

A.“P” Clamp

C. Compression sleeve

B. Brass nut

 

6.Turn on water supply to refrigerator and check for leaks. Correct any leaks.

Complete the Installation

WARNING

Electrical Shock Hazard

Plug into a grounded 3 prong outlet.

Do not remove ground prong.

Do not use an adapter.

Do not use an extension cord.

Failure to follow these instructions can result in death, fire, or electrical shock.

1.Plug into a grounded 3 prong outlet.

2.Flush the water system. See “Water and Ice Dispenser.”

NOTE: Allow 24 hours to produce the first batch of ice. Discard the first three batches of ice produced. Allow 3 days to completely fill the ice container.

Refrigerator Doors and Drawer

All graphics referenced in the following instructions are included later in this section after “Final Steps.”

Remove and Replace Handles

To Remove Handles:

1.Grasp the lower part of the handle firmly, slide the handle up and pull the handle straight out from the door. See Plastic Handle graphics 1 and 2.

To Replace Handles:

1.Position the handle so that the large holes in the mounting clips are down and align the holes with the door studs.

2.Rotate the handle so that the mounting clips are flat against the door and slide the handle down to engage. See Plastic Handle graphics 1 and 2.

Remove Doors and Hinges

IMPORTANT:

■Remove food and any adjustable door or utility bins from doors.

■Keep the refrigerator doors closed until you are ready to lift them free from the cabinet.

NOTE: Provide additional support for the refrigerator door while the hinges are being removed. Do not depend on the door gasket magnets to hold the door in place while you are working.

TOOLS NEEDED: ⁵⁄₁₆", ³⁄₈", ¹⁄₄" hex-head socket wrench, #2 Phillips screwdriver, and a flat-blade screwdriver.

5

Page 4 Page 6
Image 5
Page 4 Page 6
Contents Refrigerator User Instructions Refrigerator SafetyRemove the Packaging Clean Before Using Installation InstructionsUnpack the Refrigerator Before You Throw Away Your Old Refrigerator or FreezerRecommended Grounding Method LocationRequirementsElectrical Requirements Connect the Water Supply Water Supply RequirementsReverse Osmosis Water Supply Tools NeededConnect to Refrigerator Refrigerator Doors and DrawerRemove and Replace Handles To Remove Handles To Replace HandlesReplace Drawer Front Remove Drawer FrontReplace Doors and Hinges Remove and Replace Freezer DrawerBottom Hinges Using theControls Adjust the DoorsRefrigerator USE Opening and Closing DoorsDoor Alarm To Adjust Set Point TemperaturesFilter Reset Temperature Display FCCrisper Humidity Control To Access the User Preferences MenuIce Maker and Ice Storage Bin Water and Ice DispenserTo Clean Your Refrigerator CleaningRefrigerator Care Water Filtration SystemChanging the Light Bulb TroubleshootingRefrigerator Operation Motor seems to run too muchTemperature is too warm Temperature and MoistureIce and Water Refrigerator seems noisyWater Filter Certifications Application Guidelines/Water Supply Parameters Product Data SheetsItems Excluded from Warranty Limited WarrantyThis limited warranty does not cover Disclaimer of Implied Warranties Limitation of RemediesRéfrigérateur Sécurité DU RéfrigérateurExigences demplacement Instructions D’INSTALLATIONDéballagedu réfrigérateur Avant de jeter votre vieux réfrigérateur ou congélateurSpécificationsélectriques Méthode recommandée de mise à la terreSpécifications de l’alimentationen eau Raccordement de la canalisation deauRaccordement au réfrigérateur Achever l’installationPortes ettiroir du réfrigérateur Enlèvement de la façade du tiroir Réinstallation de la façade du tiroirCharnières inférieures Ajustement desportes Utilisation DU RéfrigérateurOuverture et fermeture des portes Style 1-Roulettes réglablesHumidity Control commande dhumidité Utilisationdes commandesDésactivation/activation du refroidissement Pour ajuster les réglages de températureMachineà glaçons et bac d’entreposage Réglage delhumidité dans le bac à légumesTaux de production de glaçons Distributeur d’eau et de glaçonsDistribution de glaçons et d’eau Éclairage du distributeurSystème de filtrationde leau Entretien DU RéfrigérateurNettoyage Nettoyage de votre réfrigérateurFonctionnement du réfrigérateur Remplacement de l’ampoule d’éclairageDépannage Les portes sont difficiles à ouvrir Température et humiditéGlaçons et eau Les glaçons sont creux ou petits Système de filtration d’eau intérieur Feuilles DE Données SUR LE ProduitGarantie Limitée Garantie DES Gros Appareils Ménagers Whirlpool CorporationArticles Exclus DE LA Garantie La présente garantie limitée ne couvre pas
Top Page Image Contents