COOKTOP USE
Cooktop Controls
WARNING
Fire Hazard
Do not let the burner flame extend beyond the edge of the pan.
Turn off all controls when not cooking.
Failure to follow these instructions can result in death or fire.
IMPORTANT: Your cooktop is
Electric igniters automatically light the surface burners when control knobs are turned to LITE.
The large burners (12,500 Btu/h [British Thermal Units]) provide the highest heat setting, and are ideal for cooking large quantities of food or liquid, using large pots and pans. The small burners (9,100 Btu/h and 6,000 Btu/h) allow more accurate simmer control at the lowest setting, and are ideal for cooking smaller quantities of food, using smaller pots and pans.
Before setting a control knob, place filled cookware on the grate. Do not operate a burner while using empty cookware or without any cookware on the grate.
To Set:
1.Push in and turn knob counterclockwise to LITE.
All surface burners will click. Only the burner with the control knob turned to LITE will produce a flame.
2.Turn knob anywhere between HI and LO. Use the following chart as a guide when setting heat levels.
SETTING | RECOMMENDED USE | |
|
|
|
Lite | ■ | Light the burner. |
|
|
|
Hi | ■ | Start food cooking. |
| ■ Bring liquid to a boil. | |
|
|
|
Medium High | ■ | Hold a rapid boil. |
Between Med & Hi | ■ | Quickly brown or sear food. |
| ||
|
|
|
Med | ■ | Fry or sauté foods. |
Medium | ■ | Maintain a slow boil. |
| ||
| ■ Cook soups, sauces and gravies. | |
|
|
|
Medium Low | ■ | Stew or steam foods. |
Between Med & Lo | ■ | Simmer. |
| ||
|
|
|
Lo | ■ | Keep food warm. |
|
|
|
REMEMBER: When cooktop is in use, the entire cooktop area may become hot.
Power failure
NOTE: Visually check that the burner has lit. If the burner does not ignite, listen for a clicking sound. If you do not hear the igniter click, turn the burner off. Check for a tripped circuit breaker or blown household fuse.
Check that the control knob is pressed completely down on the valve shaft. If the spark igniter still does not operate, call a trained repair specialist.
Proper grounding and polarity are necessary for correct operation of the electric ignition system. If the wall receptacle does not provide correct polarity, the igniter will become grounded and occasionally click, even after the burner has ignited. Contact a trained repair specialist to check the wall receptacle to see whether it is wired with the correct polarity.
In case of prolonged power failure, the surface burners can be lit manually. Hold a lit match near a burner and turn knob counterclockwise to LITE. After burner lights, turn knob to setting. Do not use a grill or griddle accessory during a power failure, as the vent fan will not operate.
6