CyberData 11111, 11113 manual Stored Network Settings, Dhcp Timeout, Current Network Settings

Installing the VoIP V3 Indoor Intercom 30

Configure the Network Parameters

2. On the Network Configuration page, enter values for the parameters indicated in Table 2-8.

Table 2-8. Network Configuration Parameters
Web Page Item	Description
Stored Network Settings
IP Addressing	Select either DHCP IP Addressing or Static IP Addressing by
	marking the appropriate radio button. If you select Static, configure
	the remaining parameters indicated in Table 2-8. If you select DHCP,
	go to Step 3.
IP Address	Enter the Static IP address.
Subnet Mask	Enter the Subnet Mask address.
Default Gateway	Enter the Default Gateway address.
DNS Server 1	Enter the DNS Server 1 address.
DNS Server 2	Enter the DNS Server 2 address.
DHCP Timeout
DHCP Timeout in seconds	Enter the desired timeout duration (in seconds) that the device will
	wait for a response from the DHCP server before defaulting back to
	the stored static IP address.
	Note: A value of -1will cause the device to retry indefinitely and a
	value of 0 will cause the device to reset to a default of 60 seconds.
Current Network Settings	Shows the current network settings.
IP Address	Shows the current Static IP address.
Subnet Mask	Shows the current Subnet Mask address.
Default Gateway	Shows the current Default Gateway address.
DNS Server 1	Shows the current DNS Server 1 address.
DNS Server 2	Shows the current DNS Server 2 address.
	Click the Save button to save your configuration settings.
	Note: You need to reboot for changes to take effect.
	Click on the Reboot button to reboot the system.

3.After changing the parameters, click Save Settings. This updates the changed parameters and reboots the Intercom if appropriate.

4.Connect the Intercom to the target network.

5.From a system on the same network as the Intercom, open a browser with the new IP address of the Intercom.

Operations Guide 930500E CyberData Corporation