Installing the VoIP V3 Indoor Intercom 34

Configure the SIP Parameters

2.4.6.2 Point-to-Point Configuration

When the board is set to not register with a SIP server (see Figure 2-17), it's possible to set the intercom to dial out to a single endpoint.

In this case, the dial-out extension should be the IP address of the remote device. The Intercom can also receive Point-to-Point calls. The delayed DTMF functionality is available in the Point-to-Point Mode.

Note Receiving point-to-point SiP calls may not work with all phones.

Figure 2-17. SIP Configuration Page Set to Point-to-Point Mode

Intercom is set to NOT register with a SiP server

Operations Guide

930500E

CyberData Corporation

Page 41
Image 41
CyberData 11111, 11113 manual Point-to-Point Configuration, Intercom is set to not register with a SiP server