Connection
The I-82H has two Speakon® NL4-type connectors wired for full range, passive operation. Connect the amplifier’s + and - outputs directly to the Speakon’s 1+ and 1- terminals.
The two connectors are wired in parallel to make parallel cabinet connection easy. Your amplifier must be able to safely power the lower impedance of parallel-connected loudspeakers.
EN | NL4 to NL4 Wiring (two- and four-conductor cables) |
| Two- or four-conductor cable may be used for Speakon to Speakon |
| connections. Four-conductor cable can be used, but the extra con- |
| ductors do not carry signal. |
| To Amplifier |
Banana to NL4 Wiring
To Amplifier
1/4” Phone to NL4
To Amplifier
The I-82H is not wired for biamp oper- ation. Do not connect biamplified equipment to the I-82H.
To Loudspeaker
To Loudspeaker
To Loudspeaker
Maintain proper speaker and amplifier connection polarity throughout the entire system. All positive-marked loudspeaker terminals should be connected to positive-marked amplifier output terminals. This will provide the best possible low-frequency output from your system.
