NORMALWASH .
DELAY WASH m
WATER HEATING 0
CLEAN 0
Changing a cycle setting
You can change a setting anytime during any cycle.
1.Lift up on the door latch to unlatch the door and stop the cycle. Do not open the door until the spray arm stops spinning.
2.Turn the Cycle Control Knob clockwise to the cycle you want.
3.Be sure the detergent dispensers are filled properly for the new cycle.
4.Close and latch the door. The dishwasher will automatically start the new cycle.
Changing an option
If you want to change a selected option, push the RESET OPTIONS Button. Reselect an option, if desired.
Using delay wash
1.Push desired Cycle Selector Button.
2.Push desired Option Selector Button(s).
3.Turn Control Knob clockwise to the number of hours (from 1 to 6 hours) you want the dish- washer to delay before the selected cycle starts.
4.Close and latch the door. The DELAY WASH Signal Light will come on until the selected cycle starts.
NOTE:
l You can add items while time is counting down. Close and latch the door. The timer will not advance if the door is unlatched.
l RINSE & HOLD and LOW ENERGY WASH Cycles can’t be delayed.
The clean signal light
The CLEAN Signal Light will come on when a washing cycle is complete. To turn it off, turn the Cycle Control Knob clockwise slightly until the light goes off.
5