2.Select a wash cycle. See chart on page 9 for cycle descriptions.
For models with rocker switches:
Skip to Step 3.
For models with three buttons:
If the Pots 8 Pans cycle will be used, push the POTS & PANS button.
For models with more than three buttons:
Push a Cycle Selector button for the desired cycle. Rinse & Hold cycle will operate with any Cycle Selector button
selected. | The | Cycle Control knob deter- | Cycles may vary with models | |
mines which | cycle operates. |
| ||
3. Turn the Cycle Control knob clockwise to |
| |||
point to the desired cycle. See page 9 for |
| |||
cycle descriptions. |
| |||
You will feel a definite stop at each cycle |
| |||
mark. The dishwasher will automatically |
| |||
start the cycls you selected. |
| |||
NOTE: If the door is latched, you will hear |
| |||
cycles start and stop as the knob passes |
| |||
each cycle mark. This is normal and will |
| |||
not hurt | the dishwasher. If you prefer, you | Cycles vary with models | ||
can set cycles with the door unlatched. | ||||
|
Adding a dish during a cycle
(model series TUD3000, TUDSOOO,TUD7000)
You can add an additional item to the dishwasher anytime before the Cycle Control knob reaches LIGHT WASH. See page 9.
1.Lift up on the door latch to unlatch the door and stop the cycle. Wait a moment for the spray action to stop before open- ing the door.
2.Open the door and add the dish.
3.Close the door. Do not latch it. Waif 30 seconds for air in the dishwasher to warm up. This helps reduce the amount of moisture that can come from the vent when restarting the cycle.
4.Press door in to latch it. The dishwasher will start where it stopped.
7