Whirlpool GMC305PD, GMC275PD, RMC275PD Using the electronic Minute Timer, Starting a function

Page 9

Using the electronic Minute Timer

The Minute Timer does not start or stop the oven. It works like a kitchen timer. It can be set in hours and minutes up to 12 hours 59 minutes. The Minute Timer will display minutes and seconds for settings under

1 hour. You will hear four 1-second tones when the set time is up unless reminder tones are disabled.

USING YOUR OVEN

When the time is up:

You will hear four 1-second tones, then four

1-second reminder tones every minute until you press TIMER OFF.

YOU SEE

TIMER

1. PRESS

YOU SEE

TIMER

SET

TIMER

2. Set time.

Press the “up” ( ▲) or “down” (▼) pad(s) until the correct time shows on the display.

PRESS	YOU SEE
HR	MIN

TIMER

	(example for 10 minutes)

3. PRESS	YOU SEE

START

ENTER

TIMER

OR

TIMER (display counts down)

SET

The Minute Timer will begin counting down immediately after the timer is started.

4. PRESS

YOU SEE

TIMER

OFF

(time of day)

To cancel the Minute Timer:

PRESS

YOU SEE

TIMER

OFF

(time of day)

Disabling the timer reminder tones:

To disable the reminder tones, press and hold TIMER SET for 5 seconds.

To enable the tones, follow the same step.

After disabling or enabling reminder tones, a single tone will sound to tell you the signals have been changed. “nAg” and “OFF” or “nAg” and “On” will appear on the display. Press START/ENTER for return to the Minute Timer countdown or the time of day dis- play.

Starting a function

After programming a function, you must press

START	START/ENTER to start the function. If you
ENTER do not press START/ENTER within
	5 seconds of programming, “START?” will

show on the display as a reminder. The control will return to time of day mode after 5 minutes if START/ENTER is not pressed.

9

Image 9

Contents 4452006A Use And CareThank you for buying a Whirlpool appliance Your safety and the safety of others is very important Oven SafetyOven Safety Model RMC275PD/RMC305PD shown Parts and FeaturesWhere to place pans Using Your OvenPositioning racks and pans Bakeware choicesElectronic oven control Using aluminum foilDisplay/clock Will occur to the oven bottom finish Do not coverSetting the clock Audible signalsSet time To cancel the Minute Timer Using the electronic Minute TimerDisabling the timer reminder tones Starting a functionWhen roasting or cooking casseroles, put food in oven Canceling a functionSet temperature optional Baking/roastingWhen baking, put food in oven after oven is preheated Adjusting the oven temperature controlSet new offset temperature Hold for Factory setting SecondsHow to determine the amount of adjustment needed Enter the adjustmentTo display temperatures in C instead of F Place the rack where you need itBroiling guidelines To custom broil at a lower temperatureUsing the electronic Mealtimer control When baking/roasting is done Set the temperature optionalSet the cook time or stop time Disabling the Cook Time reminder tonesSet the start time When the start time is reachedSet the cook time Display counts down cook timeOven vent Using the Self-Cleaning Cycle Before you start the Self-Cleaning cycle, make sure youBefore you start To start cleaning immediately Setting the controlsSet the cleaning time optional After the Self-Cleaning cycle endsAfter the Self-Cleaning cycle starts To stop the Self-Cleaning cycle at any timeExample for 230 start time Time In Hours How the cycle worksCaring for Your Oven Cleaning chartRemoving the oven door To remove Open door all the wayInsert small end of pin here Oven lights To turn the lights on or off when the oven door is closedWhen self-cleaning your oven TroubleshootingOven does not work Cooking resultsDisplay messages If you need replacement parts If you need assistance or serviceFor further assistance Our consultants provide assistance withWhirlpool