Whirlpool 2208357 manual ReversingtheDoor Swing, Connecting the drain, Side View

Connecting the drain

Gravity drain system

Connect the drain pump hose (provided with the product) to your drain in accordance with all state and local codes and ordinances. If the ice maker is provided with a gravity drain system, follow these guidelines when installing drain lines: (This will prevent water from flowing back into the ice maker storage bin and potentially flowing onto the floor causing water damage.)

■Drain lines must have a minimum of ⁵⁄₈" (1.6 cm) inside diameter.

■Drain lines must have a 1" drop per 48” [(2.54 cm) drop per 122 cm)] of run or ¹⁄₄" drop per 12” [(.635 cm) per 30.5 cm)] and must not have low points where water can settle.

■The floor drains must be large enough to accommodate drainage from all drains.

■The ideal installation has a standpipe with a 1¹⁄₂" (3.81 cm) to 2" (5.08 cm) PVC drain reducer installed directly below the outlet of the drain tube as shown. You must maintain a 1" (2.54 cm) air gap between the drain pump hose and the standpipe.

■It may be desirable to insulate the drain line thoroughly up to the drain inlet.

After ensuring that the drain system is adequate, follow these steps to properly place the ice maker:

1.Plug in ice maker or reconnect power.

2.Re-check the ice maker to be sure that it is level. See the “Leveling the Ice Maker” section.

3.Push the ice maker into position so that the ice maker drain tube is positioned over the PVC drain reducer.

SIDE VIEW

4.If it is required by your local sanitation code, seal the cabinet to the floor with an approved caulking compound after all water and electrical connections have been made.

Drain pump system (on some models)

Connect the drain pump hose (provided with the product) to your drain in accordance with all state and local codes and ordinances.

ReversingtheDoor Swing

TOOLS NEEDED: ⁵⁄₁₆" wrench, ¹⁄₄" wrench, flat putty knife, Phillips screwdriver

Hinge Pin

⁵⁄₁₆-inch Hex Head Hinge Screw

Handle Screw

Endcap Screw

To remove door from hinges:

35/8"

(9,2 cm) 1" (2,5 cm)

23"

(58,4 cm)

2" - 1 1/2"

(5 cm - 3,8 cm)

1.Drain Hose

2.1" (2.54 cm) Air Gap

3.PVC Drain Reducer

4.Center of drain should be 23” (58.4 cm) from front of door (with or without the ³⁄₄” (1.91 cm) panel on the door).

WARNING

Electrical Shock Hazard

Disconnect power before servicing.

Replace all panels before operating.

Failure to do so can result in death or electrical shock.

1.Unplug ice maker or disconnect power.

2.Remove the handle screws and handle (on some models). Keep the parts together and set them aside.

9