Whirlpool 8900 manual Starting your dishwasher using delay wash, Adding a dish during a cycle

Page 7

3.Turn the Cycle Control knob clockwise to point to the desired cycle. Heavy Wash and Pots 8 Pans cycles share the same spot on the dial. China Crystal and Light Wash cycles also share a spot on the dial. The Cycle Selector buttons deter- mine which cycle operates. You will feel a definite stop at each cycle mark. The dishwasher will automatically start the cycle you selected.

NOTE: If the door is latched, you will hear cycles start and stop as the knob passes each cycle mark. This is normal and will not hurt the dishwasher. If you prefer, you can set cycles with the door unlatched.

Starting your dishwasher using delay wash

You can set the dishwasher to start a cycle from 1 to 6 hours later.

1.Push desired Cycle Selector button.

2.Push desired Option Selector button(s).

3.Turn Cycle Control knob clockwise to the number of hours (from 1 to 6 hours) you want the dishwasher to delay before the selected cycle starts.

4.Close and latch the door. The DELAY signal light will come on until the selected cycle starts.

NOTE:

l You can add items while time is counting down. Close and latch the door. The Cycle Control knob will not advance if the door is unlatched.

l Rinse & Hold, Light Wash and China Crystal cycles cannot be delayed.

Adding a dish during a cycle

You can add a forgotten item to the dishwasher reaches LIGHT WASH. See page 9.

1.Lift up on the door latch to unlatch the door and stop the cycle. Wait a moment for the spray action to stop before open- ing the door.

2.Open the door and add the dish.

3.Close the door. Do not latch it. Wait 30

anytime before the Cycle Control knob

seconds for air in the dishwasher to warm up. This helps reduce the amount of moisture that can come from the vent when restarting the cycle.

4.Press door in to latch ft. The dishwasher will start where it stopped.

7

Image 7
Contents Series Dishwashers Thank you for buying a WhirlpooP appliance Your safety is important to usHelp us help you Important Safety InstructionsParts And Features Cycle control knob ButtonsThis Section MIml~mg0 l D1 Using Your DishwasherBefore starting your dishwasher Starting your dishwasherAdding a dish during a cycle Starting your dishwasher using delay washChanging an option Changing a cycle settingCanceling a cycle Cycle selection chartMain Time Cycle Wash Rinse Wash Rinse Option What happens in eachDoes not move Signal lights Cover Using the detergent dispenserWhat type of detergent to use Detergent dispenserTo check dispenser Using the rinse agent dispenserHow much detergent to use Rinse agent dispenserTo fill dispenser Quiet operating tipsOn some models To check water temperature Water temperature tipsEnergy saving tips Special tips on dishwasher use Cup and glass load Loading Your DishwasherPreparing to load the dishwasher Loading the top rackUtensil load Infinite adjustable top rackLoading the bottom rack Mixed loadFold down divider Loading the silverware basketPersonal Injury Hazard To open the basket Loading the cutlery basketTo remove the basket To replace the basketCleaning the interior Cleaning the exteriorCaring For Your Dishwasher Solution chart Common Dishwashing ProblemsProblem Cause Solution Removing spots and film ProblemCauseSolutionBefore calling for assistance If You Need Assistance Or ServiceIf you need FSP replace- ment parts If you need serviceIf you are not satisfied with how the problem was solved If you need assistancePower Cleantm washing system parts covered by your warranty Part no Rev. a Whirlpool