Whirlpool 8900 manual Changing a cycle setting, Changing an option, Canceling a cycle, Cycle

Page 8

Changing a cycle setting

You can change a setting anytime during any cycle.

1.Lii up on the door latch to unlatch the door and stop the cycle.

2.Turn the Cycle Control knob clockwise to the cycle you want.

3.Push the desired Cycle Selection button.

4.Check the detergent dispenser to be sure it is properly filled for the new cycle. See page 12.

NOTE: Turning the Cycle Control knob may cause the covered section of the detergent dispenser to open. Be sure to fill the covered section if the cycle uses detergent in both sections.

5.Close and latch the door. The dishwasher will automatically start the new cycle.

Changing an option

You can change an option anytime during a cycle. To change the selected option(s):

1.Push the RESET OPTIONS button.

2.Push an Option Selector button for each desired option.

Canceling a cycle

You can cancel a cycle anytime during the cycle.

1.Turn the Cycle Control knob slowly clockwise to the drain portion of the wash or rinse. You will hear water draining when you have advanced to the proper location.

2.Let the dishwasher drain completely.

3.Lii up on the door latch to unlatch the door.

4.Turn the Cycle Control knob clockwise to point to OFF.

,Cycle selection chart

A “enshows what steps are in each cycle Cycle

cycle

Pots & Pans

A double wash for maximum cleaning of cooked-on or

baked-on foods.

NOTE: The Cycle Control knob stops while the dishwasher heats water to 135°F (57°C) in both washes and the final rinse (marked T). See page 10.

MainTime Wash Rinse Wash Rinse Rinse Dry (Minutes)

l t

.

l t

0

l t

.

90-l 20’

8

Page 7 Page 9
Image 8
Page 7 Page 9
Contents Series Dishwashers Your safety is important to us Thank you for buying a WhirlpooP applianceImportant Safety Instructions Help us help youParts And Features Buttons Cycle control knobMIml~mg0 l D1 Using Your Dishwasher Before starting your dishwasherStarting your dishwasher This SectionStarting your dishwasher using delay wash Adding a dish during a cycleChanging a cycle setting Canceling a cycleCycle selection chart Changing an optionMain Time Cycle Wash Rinse Wash Rinse Does not move What happens in eachOption Signal lights Using the detergent dispenser What type of detergent to useDetergent dispenser CoverUsing the rinse agent dispenser How much detergent to useRinse agent dispenser To check dispenserOn some models Quiet operating tipsTo fill dispenser Energy saving tips Water temperature tipsTo check water temperature Special tips on dishwasher use Loading Your Dishwasher Preparing to load the dishwasherLoading the top rack Cup and glass loadInfinite adjustable top rack Loading the bottom rackMixed load Utensil loadPersonal Injury Hazard Loading the silverware basketFold down divider Loading the cutlery basket To remove the basketTo replace the basket To open the basketCaring For Your Dishwasher Cleaning the exteriorCleaning the interior Problem Cause Common Dishwashing ProblemsSolution chart Solution ProblemCauseSolution Removing spots and filmIf You Need Assistance Or Service Before calling for assistanceIf you need service If you are not satisfied with how the problem was solvedIf you need assistance If you need FSP replace- ment partsPower Cleantm washing system parts covered by your warranty Whirlpool Part no Rev. a
Top Page Image Contents