INSTALLATION INSTRUCTIONS
REMOVING AND REPLACING THE MICROWAVE OVEN
wWARNING
Excessive Weight Hazard
Use two or more people to move and install microwave oven.
Failure to do so can result in back or other injury.
If you need to remove your Microwave Hood Combi- nation for any reason, follow these simple steps:
4. While wearing gloves, grasp the microwave oven
supports and firmly
E | pull the microwave oven | ||
forward and downward to | |||
| |||
| release the microwave | ||
| oven cabinet from the | ||
| mounting plate locking | ||
| pins | . |
To remove:
1.Unplug microwave oven or disconnect power.
2.Remove filters and vent grille.
•If filters are
Binstalled, push in at the tab and slide filter to the
C | outside edge to remove. | |
| • Remove the two | |
| screws | from the top |
| of the microwave oven | |
| cabinet (the screws | |
| located closest to the | |
| front corners). Do not |
Aremove the screws
located towards the center of the cabinet.
•Remove the vent grille . Set the screws and grille aside.
3.After removing all oven contents, including the turntable and support, tape the door in the closed position. Then remove the two bolts
D | securing the |
| microwave oven to the |
| upper cabinet. |
F |
5.Grasp the microwave oven cabinet. Rotate the microwave oven down-
G | ward. (Be careful that | ||
door does not swing | |||
| |||
| open.) Lift off the support | ||
| tabs | at the bottom of | |
| the mounting plate. Set | ||
| the microwave oven | ||
| aside on a protected | ||
| surface. |
|
continued on next page
7