CARING FOR YOUR MICROWAVE OVEN
INSTALLING AND CARING FOR THE FILTERS
Do not allow grease and soil to build up in the grease filters. It will decrease the exhaust fan efficiency and could cause a fire. Remove and clean grease filters at least once a month.
NOTE: If your microwave hood combination is installed to recirculate air, you should install the charcoal filter accessory (PN 4393690). The char- coal filter cannot be cleaned and should be replaced every 6 to 12 months. To order the filter, call
wWARNING
Electrical Shock Hazard
Disconnect power before removing filters.
Replace all panels before operating.
Failure to do so can result in death or electrical shock.
Removing, cleaning, and replacing
1.Unplug microwave oven or disconnect power.
2.To remove the grease filters (PN 4393691), push each filter up on the side opposite the tab. Grasp the tab and slide the filter to the side. Pull the
filter downward. It will drop out.
3. To remove the charcoal filters, push the back
| of each filter away from |
| you. This will slide the |
| front of the filter off the |
| lower lip. Swing the |
| front of the filter down |
Upper | and slide the filter out. |
| |
lip |
|
4.
5.To replace the charcoal filters, push each filter to the back of the opening, between the
upper and lower lips against the springs. Swing the front of the filter up against the upper lip. Slide the filter forward while pushing it up against the upper lip. The filter will now be held in position be- tween the lips by the spring.
6.To replace the grease filters, slide each filter into the outer side of the filter opening. Make sure you are sliding in the side of the filter that
does not have the tab. Hold the tab with your other hand. Push up the tab side of the filter and slide the filter to the other side of the opening to lock into place.
7.Plug in microwave oven or reconnect power.
NOTE: Do not operate the vent fan without the filters in place.
31