Whirlpool MH3184XPS5 installation instructions Cd E, Roof Venting Installation Only

Page 5

5.Rotate blower motor end over end.

6.Rotate blower motor so that exhaust ports face the back of microwave oven, and lower blower motor back into the microwave oven.

A

A. Exhaust port

7.Reattach blower motor to back of microwave oven with 2 screws removed in Step 3.

8.Reattach damper plate. Make sure tabs at top and back of damper plate are inserted fully into their respective slots in the microwave oven.

A B CD E

A. Damper plate

B. Tabs at back of damper plate

C. Slots in back of microwave oven exterior

D. Damper plate tabs

E. Slots in top of microwave oven exterior

9. Secure damper plate with screw.

Roof Venting Installation Only

1.Repeat Step 1 from “Wall Venting Installation Only.”

2.Repeat Step 2 from “Wall Venting Installation Only.”

3.Repeat Step 3 from “Wall Venting Installation Only.”

4.Repeat Step 4 from “Wall Venting Installation Only.”

5.Rotate blower motor so that exhaust ports face the top of microwave oven, and flat sides of blower motor face back of microwave oven. Lower blower motor back into microwave oven.

A

A. Exhaust port

IMPORTANT: If blower motor is not positioned with flat sides facing the back of the microwave oven (as shown), performance will be poor.

6.Reattach blower motor to back of microwave oven with

2 screws removed in Step 3 of “Wall Venting Installation Only.” Securely tighten screws.

NOTE: If blower motor is not correctly oriented, the 2 screws removed in Step 3 cannot be reattached to the microwave oven.

7.Reattach damper plate. Make sure tabs at top and back of damper plate are inserted fully into their respective slots in the microwave oven.

A B CD E

A. Damper plate

B. Tabs at back of damper plate

C. Slots in back of microwave oven exterior

D. Damper plate tabs

E. Slots in top of microwave oven exterior

8. Secure damper plate with screw.

5

Image 5
Contents Microwave Hood Combination Safety Microwave Hood Combination Installation InstructionsToolsandParts Installation RequirementsRemoveCardboardTemplate LocationRequirementsInstallation Dimensions ProductDimensionsElectricalRequirements RequiredWall Venting Installation Only Installation InstructionsRemoveMountingPlate RotateBlowerMotorCD E Roof Venting Installation OnlyLocateWallStuds Possible Wall Stud ConfigurationsNo Wall Studs at End Holes Wall Stud at One End Hole Wall Studs at Both End HolesDrillHolesinRearWall Installation for No Wall Studs at End Holes Figures 1MarkRearWall PrepareUpperCabinet AttachMountingPlatetoWallInstalltheMicrowaveOven InstallDamperAssemblyCompleteInstallation For optimal venting installation, we recommend Venting Design SpecificationsRectangular to Round Transition Recommended Standard FittingsAccessories ReplacementPartsAssistance ¹⁄₄ x 10 8.3 x 25.4 cm vent system = 73 ft 22.2 m total