R
Santa Fe Pellet Insert
H.Baffle & Brick Set Removal
1.Follow proper shutdown procedures in Section 10.
2.The top baffle has a hook on the bottom left side that rests on the top lip of the cast brick. There is a tab on the bottom right side that hooks into the side bracket. Remove the top baffle by first pulling the baffle forward until back edge drops down. Then slide baffle back until the front edge clears the shelf that it had been resting on.
Figure 37.1.
3.The top baffle must be removed before you can remove the right and left brick. Remove the right brick by hold- ing top lip of brick and lifting up, then push outside edge back. Slide brick to the right until it is flush with the firebox. Rotate the inside edge of the brick forward and remove brick. Repeat for left brick. Figure 37.2.
Hook on
left sideTab on right side
Figure 37.1
Remove Right
& Left Brick
Figure 37.2
Re-installing Baffle & Brick Set
1.Place right brick in behind the right bracket, and then slide to the left so the tabs are behind the center brick.
Figure 37.4.
2.The brick will be flush against the back wall and notches exposed in the side bracket. Figure 37.5.
3.Lift slightly and pull the right edge of the brick forward until it stops and then drops down into both top and bottom notches of right bracket and locks into place. Figures 37.1 and 37.2.
4.Repeat for left brick.
5.Insert baffle into top front inside the firebox and pull for- ward. Then raise up the bottom end and insert baffle tab into slot on the top of the right bracket to lock into place. Figure 37.3. Place the left side hook at the bottom of the baffle over the top edge of brick for stability. Figure 37.4.
6.The baffle does not completely cover the top of the firebox. There is an opening on the left as shown in Figure 37.5.
Tabs
Figure 37.4
Brick is flush against back wall
Right Brick
Removed
Notches exposed
Vacuum
Exhaust Area
Figure 37.5
Figure 37.3
September 1, 2008 | Page 37 |