Hearth and Home Technologies SANTAFEI-B Santa Fe Pellet Insert Thermostat Installation, Left Side

R

Santa Fe Pellet Insert

J. Thermostat Installation

1. A 12 volt AC thermostat is required to operate this pellet appliance. You may use the included wall mount thermo- stat or purchase an optional programmable thermostat or remote control.

The included thermostat is equipped with an adjustable heat anticipator. The current rating is .05 amps. The anticipator needs to be adjusted to the lowest setting available.

2.When mounting a thermostat on a wall, be sure to follow your thermostat installation instructions carefully.

NOTE: Thermostat must be mounted level for accu- rate readings. The thermostat should be mounted on an inside wall and not in direct line with the appliance convection air. Remove any packaging from inside the thermostat before using.

NOTE: If the thermostat is located too close to the appliance, you may need to set the temperature setting slightly higher to maintain the desired tem- perature in your home.

3.There is a 4 screw terminal block located on the junction box to the right of the power cord inlet. The center 2 screws are for the thermostat wires. The outer 2 are the mounting screws for the terminal block. Figure 23.1.

	Cut Away
			LEFT SIDE
			unction Box
	unction Box, Front
Power	Red Call	Fuse	110 Outlet for
Cord	Light		Remote
Recepticle			Control Only
Terminal Block			(unfused)
Center 2 Screws
for Thermostat
Wires or Remote

CAUTION

Shock hazard.

•Do NOT remove grounding prong from plug.

•Plug directly into properly grounded 3 prong receptacle.

•Route cord away from appliance.

•Do NOT route cord under or in front of appli- ance.

Figure 23.1

CAUTION

The 110 outlet on the junction box is for a remote control ONLY. Do not use outlet for any other purpose. It can damage the appliance and it will void your warranty.

September 1, 2008 7019-205C Page 23