Whirlpool RM280PXA warranty Skip to Step

Page 27

If a cleaning cycle other than 3 hours is desired, use the Hour and Minute pads to set the desired cleaning time. Push the “up”(A) or “down” (V) pad(s) until a time between 2-4 hours shows in the display.

l

l

Use 2 hours for light soil.

Use 3-4 hours for moderate to heavy soil.

Push the Start/Enter pad. TIMED and HEAT will light up in the display to show that the oven is promgrammed for the Self-Cleaning

Cycle.

NOTE: The display will show “door’ and a tone L\III sound once a minute for 5 minutes if the door is not latched.

Skip to Step 4.

Push the Start/Enter pad. DELAY, CLEAN and the time of day will light up in the display to show that the oven is programmed to start the Self-Cleaning cycle at a later time.

Skip to Step 4.

r- L /

Image 27

Contents GallIwithquertionsorumlments If YouThank you for buying a Whirlpool appliance Your safety is important to usImportant Safety Instructions Ing grease outside of pan can Parts And Features This Positioning racks and pansFor best air circulation Using aluminum foil for bakingCommand pads Electronic oven controlDisplay/clock Using the electronic Minute Timer Setting the clockUsing the Off/Cancel pad Audible signalsTo cancel the Minute Timer Baking/roasting Adjusting the oven temperature control Broiling To broil at a lower temperatureRack position chart Broiling tipsEnergy saving tips Position the oven racks properly and put food in the oven Using the electronic Mealtimer controlMethod Z-Using Stop Time Page Position the oven racks properly and put food in the oven Page Method Z-Using Start Time and Stop Time Page Method 3-Using Cook Time and Stop Time Page Oven vent Howthe cyck wortu How the cycle worksBefore you start This Section PawSetting the controls Skip to Step To delay the start using Start Time To stop the Self-Cleaning cycle at any time Special tipsThis Section HOW to Clean Cleaning chartTo replace the oven light Oven lightBefore calling for assistance If You Need Assistance Or ServiceIs not level If you need FSP replace- ment parts If you need serviceIf you are not satisfied with How the problem was Solved If you need assistancePage LM=iIRLPOOL@