Mounting your extractor
IMPORTANT NOTE:
The extractor is now mounted and secured to the wall; the electrical connections are now required to be made in order for the extractor to function.
1.Ensure that there are no trapped wires - The mains lead and control wires are easily trapped when securing the stainless section to the motor.
2.Locate the main terminal box (on the left as you look at it) and remove the 2 screws, shown as D on the diagram below. Connect the main connector plug (Shown as B in the diagram) and replace the cover.
3.Locate the control terminal box (on the right) and remove the 2 screws. Connect the connector as shown in the diagram (A) and refit the terminal cover.
Fig. 16 |
10