Using your Extractor

For best performance, you should switch on the extractor 15 minutes before starting to cook and leave it to run for approximately 15 minutes after the end of cooking.

Control Panel

A – Light button

B, C, D – Speed level buttons

E – Power off button

F – Timer button

To switch the extractor light on or off

•Press button A.

To switch on the extractor or to change the speed at any time when the extractor is running

•Press button B, C or D for the first, second or third speed level as required.

To switch the extractor off

•Press button E.

The intensive function

•The extractor is equipped with an intensive function which runs for ten minutes before returning to the previous selected speed. To activate the intensive function, press and hold button B for two seconds B. Button E will flash whilst the intensive function is on. To cancel the intensive function, press button E again.

The timer

•The extractor is equipped with a timer that allows the extractor to run for 15 minutes before switching off automatically.

•To activate the timer, touch button F.

Please note

The timer cannot be activated when the intensive function is on.

The clean air function

•The extractor is equipped with a clean air function that switches on the motor for ten minutes every hour at speed one.

•To activate the clean air function, press and hold button F for two seconds when the appliance is off. To return to normal function, press the button B, C or D for the speed required. To switch off the extractor, press button E. Buttons C and F will flash whilst the motor is running, and button F will be lit during the fifty minutes when the motor is not running.

Fig. 1