DeLonghi EUROCHEF - PRO Connect Ductwork, Install Duct Covers Connect Electrical

EUROCHEF - PRO WALL HOOD

STEP 4: CONNECT DUCTWORK

•Install ductwork.

•Secure joints in ductwork and transition with sheetmetal screws and duct tape for an airtight seal.

•ATTENTION: Be sure that screws do not hamper the dampers movement.

•Use wire nuts to connect incoming ground, neutral and hot.

•Push wires into junction box and replace cover. Be sure wires are not pinched.

STEP 6: INSTALL DUCT COVERS

STEP 5: CONNECT ELECTRICAL

Verify that power is turned off at the source.

WARNING

If house wiring is not 2-wire with a ground wire, a ground must be provided by the installer. When house wiring is aluminum, be sure to use U.L. approved anti-oxidant compound and alumi- num-to-copper connectors.

ATTENTION

Sí le câblage de la maison n’est pas du type a deux fils avec un fil de terre, l’installateur doit fournir un circuit de terre. Quand les fils de la maison sont en aluminium, il prendre soin d’utiliser de la pâte antioxidation approuvée par UL et des connecteurs pour l’aluminium-cuivre.

GREEN = GROUND

BLACK & BROWN = HOT

BLUE & WHITE = NEUTRAL

ASSEMBLY AND INSTALLATION

OF THE DUCT COVERS &

RECIRCULATING KIT COVER

Optional duct covers shown in advance planning section may be used to fill the space between the hood and ceiling in wall mount installations. 6" and 12" high duct covers are available and may be ordered separately.

1.If multiple duct covers are used, connect the pieces together using sheetmetal screws provided with duct covers. Remove plastic film.

2.Attach the duct cover(s) to the hood using screws provided.

3.From inside of hood, insert screws supplied (3,5 x 9,5) through holes in front and side of hood into covers.

12 Air-2