DeLonghi EUROCHEF - PRO Tighten Hanging Screws, RE-INSTALL the Filter Frame

Page 13

EUROCHEF - PRO WALL HOOD

STEP 7: TIGHTEN - HANGING SCREWS

•With Filter Frame still removed from Step 2

•Adjust hood up to eliminate any gaps at ceiling. Tighten hanging screws.

•Add (2) more security screws + Washers at wood bracket.

•IMPORTANT: If Installing optional Backsplash Kit install this kit BEFORE installing wall anchors

(see instruction with kit)

Install Bottom Wall Anchors

•Drill 1//8" pilot holes into the two lower mounting holes. Enlarge the holes if they did not enter studs to 3/8".

•Install (2) or (3) wall anchors at bottom of hood.

•Remove anchor screws and add a flat washer provided. Drive screws into anchors and tighten.

•If a Wood Stud was discovered at wall anchor locations use 80mm Wood Screw supplied with Washer (instead of Wall anchor). Drive screws and tighten.

STEP 8: RE-INSTALL THE FILTER FRAME

•Use screws removed in Step 2 to re-install Filter Frame, per photograph.

Air-2		13

Image 13

Contents Read and Save These Instructions Eurochef PRO Wall HoodHoods Eurochef PRO Wall HoodRead These Instructions Completely and Carefully Product Dimensions Contents and page NumberAdvance Planning Using Duct Cover AccessoriesParts Provided Remove the RangehoodPrepare Hood for Installation Determine HOOD, Ductwork and Wiring LocationsFor Ducting Through Wall Please see Template Junction BOX LocationBlower Position Option Blower Position ChartHood size Motor If Changing Blower Position Security Screw Blower Upgrade KIT 30 and 36 HoodsHang Hood On Wood Bracket Test Duct Cover Fit do not install Duct coversAlternate Mounting Method Skip this Step if Using Wall Mounting MethodMount Hood onto Soffit or Cabinet Verify that power is turned off at the source Install Duct Covers Connect ElectricalConnect Ductwork Tighten Hanging Screws RE-INSTALL the Filter FrameInstall Filter Test Function of Hood Cleaning Hood Cleaning FiltersWarranty Care and USE Replacing Halogen BulbEurochef U.S.A