Bertazzoni Z36500X, C36500X, C36600X, Z36600X manual Using Burners, Manual ignition

Page 11

USING BURNERS

A diagram is etched on the control panel above each knob which indicates which burner corresponds to that knob.

Manual ignition:

Manual ignition is always possible even when the power is cut off or in the event of prolonged power failure.

Turn the knob that corresponds to the burner selected counterclockwise to the MAXIMUM position at the etched star (large flame) and place a lit match up to the burner.

Automatic electric ignition:

Turn the knob that corresponds to the burner selected anticlockwise direction to the MAXIMUM position at the etched star (large flame) and then press the knob down to activate the spark ignition. Once ignited, keep pressing the knob for about 10 seconds to allow the flame to heat the thermocouple. If the burner does not remain alight after releasing the knob repeat the above procedure,

Note: It is recommended not to try to ignite the burner if the relative flame cap is not in the correct position

Note: Dual burner is composed by two burner (inside and outside); each one operates under the relative gas valve indipendently from the other one.

Tips for using burners correctly:

WARNING: During use of each gas burner(s) adjust the burner flame size properly so it does not extend beyond the edge of the cooking utensil. This is an instruction based on safety considerations

-Use suitable pots for each burner (see Fig. and Table )

-When the liquid is boiling, turn down the knob to the MINIMUM position.

-Always use pots with a cover.

Correct flame aspect: verify that aspect flame of the worktop burners be completely blue and with an aspect as indicated in figure(flame)

Table

 

Burner

Recommended pan diameters inches (mm)

 

 

Small

3½”-51/2”(90 – 140)

 

 

Medium

51/2”- 101/4”(140 – 260)

 

 

Large

71/8”- 101/4” (180 – 260)

 

 

Dual burner

82/3”-101/4 (220 – 260)

 

 

 

 

 

 

 

 

 

 

 

 

 

 

 

 

 

 

 

WARNING: check the position of the burner caps before operation.

Correct usage of pans:

-Dry the bottom of the pan before placing it on the hotplate.

-Use pots with a flat, thick bottom, except for wok cooking.

-When using the burners, ensure that the handles of the pans are correctly positioned. Keep children away from the appliance.

-When cooking foods with oil and fat, which are very flammable, the user should not leave the appliance unattended.

WOK PAN: To use the wok pan, please utilize a suitable wok adaptor grid; wok pan external diameter shall not be less than 10” (25cm) and not more than 16”(40cm).

WARNING: If the power is cut off, the burners can be lit with matches.

The burners equipped with a safety thermocouple can only be lit when the knob is in the MAXIMUM position (large flame etching).

11

Image 11
Contents Bertazzoni Requirements Room ventilation Location and venting Worktop Frontguard Installation Instructions Backguard Installation InstructionProximity to Side Cabinet Installation Electrical Connection Cooker Hood InstallationPage Final Preparation GAS ConnectionConversione to Different Types of GAS Replacement PartsModels C36600X Z36 6 00 X C3Y0..U4X2 or 5A Control Panel Description Service & Maintenance InstructionsDescriptions Manual ignition Using BurnersAfter Sale Service Cleaning the ApplianceSpare Parts List Page