OPERATION
Controls
The hood is operated using the slide controls under the front edge of the hood.
The light switch turns the halogen lights on and off.
The blower on / off switch turns the blower on to the running speed set by the blower speed control. The blower must be turned on and off using this switch.
The blower speed control changes the running speed of the blower
LIGHT |
| BLOWER |
SWITCH | BLOWER | ON / OFF |
| SWITCH | |
| SPEED | |
|
| |
| CONTROL |
|
PILOT
LAMP
The pilot lamp lights up whenever the blower is on.
HEAT SENTRY™
Your hood is equipped with a HEAT SENTRY™ thermostat. This thermostat is a device that will turn on or speed up the blower if it senses excessive heat above the cooking surface.
1)If blower is OFF - it turns blower ON to HIGH speed.
2)If blower is ON at a lower speed setting - it turns blower up to HIGH speed. When the temperature level drops to normal, the blower will return to its original setting.
WARNING
The HEAT SENTRY thermostat can start the blower even if the hood is turned OFF. When this occurs, it is impossible to turn the blower OFF with its switch. If you must stop the blower, do it from the main electrical panel.
HALOGEN BULBS
This range hood requires two halogen bulbs (Type MR16, 12V, 20W).
ALWAYS SWITCH OFF THE ELECTRICITY SUPPLY BEFORE CARRYING OUT ANY OPERATIONS ON THE APPLIANCE.
To change bulbs:
1.Slacken the ring nut in an anticlockwise direction.
2.Remove the bulb by pulling sideward (Do not rotate). CAUTION: BULB MAY BE HOT!
3.Replace with a bulb of the same type.
BULB
RING NUT
If lights fail to operate, disconnect power at the service entrance. Check fuse and replace if necessary.
- 9 -