ASSEMBLY AND SET-UP
Installation of Turntable Platter
○1 By placing the turntable platter on the center spindle, the platter adjusts to match the spindle by itself.
○2 Place the slip mat on the platter.
○3 Extra care should be taken to avoid damaging magnet by dropping it.
N O T E
Never connect the AC power plug before assembly has been completed.
Installation of Balance Weight
○1 Place the balance weight on the rear shaft of the
Method of Using Slip Mat
○1 Place slip mat on the turntable platter, and place the record on the slip mat. It is possible to stop and return the record by hand while the turntable revolving.
Installation of Cartridge
○1 In accordance with the instructions of the cartridge, install a cartridge properly.
NUT
○2 Connect the lead wires to the cartridge terminals. The terminals of most cartridges are color corded. Connect each lead wire to the terminal of the same color.
|
|
|
|
|
| SHELL |
Red (R+) |
| Right Channel+ | Green |
|
| Right Channel - SHELL WEIGHT |
|
| |||||
White |
| Left Channel+ | Blue |
|
| L e f t Channel - |
|
|
| ||||
|
|
|
|
|
| CARTRIDGE |
N O T E
In case the cartridge weight is less than 8g, it is
necessary to fix the attached shell weight on the STYLUS cartridge.
SCREWS
Surface of slip mat (printed): Disk side
Inside of slip mat : Slip side
LEAD WIRE
TERMINAL
6