Zephyr ZNA-E42S, ZNA-M90S manual Installation - Mounting Height & Clearance, Ducting

Page 8
Installation – Mounting Height & Clearance

www.zephyronline.com

Installation – Mounting Height & Clearance

Min.ducted 33”

Min.recirc.

33”

Max.

48”

Min 28"-Max 36"

 

 

Min 8’ 1"

 

Max 10’

36"

 

DUCTING

 

A minimum of 6” round ducting must be used to maintain maximum air flow efficiency.

Always use rigid type metal ducts only. Flexible ducts could restrict air flow by up to 50%.

Use calculation worksheet to compute total duct work.

ALWAYS, when possible, reduce the number of transitions and turns. If a long duct run is required, increase duct size from 6” to 7” or 8”.

If turns or transitions are required: Install as far away from opening and as far apart, between 2, as possible.

Minimum mount height between range top to hood bottom should be no less than 28”.

Maximum mount height should be no higher than 36”.

It is important to install the hood at the proper mounting height. Hoods mounted too low could result in heat damage and fire hazard; while hoods mounted too high will be hard to reach and will loose its performance and efficiency.

If available, also refer to range manufacturer’s height clearance requirements and recommended hood mounting height above range. Always check your local codes for any differences.

Mounting Height (Recirculating or Ducted) Minimum Ceiling Height 8’1”. Hood mounted 28” above cooking surface; 64” from floor. Maximum Ceiling Height 10’ 1”. Hood mounted 36” above cooking surface; 72” from floor.

Duct cover extension kit available for ceiling heights up to 12 feet. Turn to page 18 for part number and ordering information.

DAMAGE-SHIPMENT / INSTALLATION:

Please fully inspect unit for damage before installation.

If the unit is damaged in shipment, return the unit to the store in which it was bought for repair or replacement.

If the unit is damaged by the customer, repair or replacement is the responsibility of the customer.

If the unit is damaged by the installer (if other than the customer), repair of replacement must be made by arrangement between customer and installer.

6

Image 8
Contents Use, Care, and Installation Guide Napoli IslandPage Table of Contents INSTALLATIONMAINTENANCE Hood and Filter CleaningImportant Safety Notice READ AND SAVE THESE INSTRUCTIONSOPERATION ELECTRICAL REQUIREMENTSList of Materials MODELS ZNA-M90S, ZNA-E42S PARTS SUPPLIEDInstallation - Ducting Calculation Sheet Installation - Mounting Height & Clearance DUCTINGOptions Installation - DuctingWARNING FIRE HAZARD Soffit or crawl spaceInstallation - Hood Specifi cationstop of hood blower housing and ceiling bracket front of hoodInstallation - Mounting the Hood Mount hood onto support frame 6. Lift lower duct cover and hood body onto bottom of support frameInstallation Ductless RecirculationCharcoal Filter Replacements RECIRCULATING KIT REQUIRED IF NO DUCTING IS USEDFeatures & Controls Touch ControlsAdjust 6 Speed Levels 15 Min Delay Off 1. Blower On/Off Lights On/Dim/OffReminder FilterCharcoal Filter Change Reminder charcoal filter, if installed Setting the Filter Change ReminderFilter Clean Reminder Features & Controls - Metal MeshMetal Filter Clean Reminder metal mesh filter Metal Filter Clean IndicatorMaintenance - Hood and Filter Cleaning SURFACE MAINTENANCEMetal Filters Replacing Metal FiltersREPLACING LIGHT BULBS Maintenance - LightsCAUTION Light bulb becomes extremely hot when turned on Troubleshooting TROUBLESHOOTING PROCEDURES FOR NAPOLI ISLANDIssue CauseList of Parts and Accessories Replacement PartsOptional Accessories DESCRIPTIONLimited Warranty JUN08.0101