Zephyr CTP-E 48SX, CTP-E 60SX, CTP-E54SX manual Ins ta lla tion Interna l B lower

Page 10

Ins ta lla tion - Interna l B lower

www.zephyronline.com

ATTENTION

The following are intructions for installing internal blower model CBI-600. For instructions on preparing for external blower model CBE-1000 please turn to page “10”. Before installing, verify that motor spins freely.

The internal blower kit consists of the blower	1. Remove existing screws from blower
and capacitor box with wiring.	housing.

2. Att ach capacitor box to blower housing	3. Att ach motor connector to capacitor box
using the removed screws.	connector.

4. P osition internal flange over blower	5. Att ach (4) 1/2” 5x15mm screws and (4)
housing.	10mm washers to hold flange to blower
	housing.

8

Image 10

Contents Use, Care, and Installation Guide Page Table of Contents InstallationImportant safety Notice Read and Save These InstructionsLis t of M a teria ls Model CTP-ExxSIns ta lla tion Ductwork C a lcula tion S heet Duct pieces Equivalent number TotalInstallation Mounting Height & Clearance Minimum Duct SizeTion Ducting Ins ta llaSpecifications Ins ta lla tion Interna l B lower Included with the external blower Continue to page 11 for hood Installation instructions Ins ta lla tion P repa ring Hood for E xterna l B lowerInstallation Mounting the Hood Electrical WarningIns ta lla tion M ounting the Hood Ductwork Electrical wiring On top of hood and secure with medium set screw Fea tures & C ontrols Touch C ontrols & F ea tures Re-setting Function Filter Clean ReminderHa nge Indica tor Baffle Filters Surface MaintenanceNce C le aning Replacing Baffle FiltersIntena nce Lights Issue Cause What to do HootingAccessory Description List of Parts and AccessoriesPart Description Warranty