INSTALLATION
Sleeve
L Key
RKey
4.Mount the sleeve by inserting the sleeve into the opening of the dashboard and bend open the tabs located around the sleeve with a screwdriver. Not all tabs will be able to make contact, so examine which ones will be most effective. Bend open the appropriate tabs behind the dashboard to secure the sleeve in place.
Dashboard
Tabs
Screwdriver
Sleeve
5.Reconnect the wire harness and the antenna and be careful not to pinch any wires or cables.
6.Slide the unit into the sleeve until it locks into place.
7.To further secure the unit, use the supplied metal strap to secure the back of the unit in place. Use the supplied hardware (Hex Nut (M5mm) and Spring Washer) to attach one end of the strap to the mounting bolt on the back of the unit. If necessary, bend the metal strap to fit your vehicle's mounting area. Then use the supplied hardware (Tapping Screw (5x25mm) and Plain Washer) to attach the other end of metal strap to a solid metal part of the vehicle under the dashboard. This strap also helps ensure proper electrical grounding of the unit.
Note: to install the short threading terminal of the mounting bolt to the back of the unit and the other long threading terminal to the dashboard.
Hex Nut
Metal Strap
Mounting Bolt
Plain Washer
Tapping Screw
8.Reconnect the cable to the vehicle battery's negative
Removing the unit
1.Remove the metal strap attached to the back of the unit (if attached).
2.Press the OPEN/CLOSE button to slide the front panel down.
Open
3.Insert fingers into the groove in the right side of the outer trim ring and pull out to remove the outer trim ring. (You can also remove the outer trim ring from the left side.)
Outer trim ring
4