INSTALLATION
4.After removing the outer trim ring, press OPEN/CLOSE button again to slide the front panel up. Then insert both of the supplied keys into the slots at the left and right sides of the unit, then pull the unit out of the dashboard.
DIN REAR-MOUNT (Method B)
If your vehicle is a Nissan or a Toyota, follow these mounting instructions. Use the screw holes marked T (Toyota) or N (Nissan) located on both sides of the unit to fasten the unit to the factory radio mounting brackets supplied with your vehicle.
Side view showing
Screw Holes marked T, N
Factory Radio |
| Screw |
Mounting |
|
|
Bracket |
|
|
|
| Hook |
Screw | Hook | Dashboard or |
| ||
| Console | |
|
|
To fasten the unit to the factory radio mounting brackets.
1.Use a screwdriver to loose the hook's screws on the front left and right sides of the unit and remove the hooks.
2.Align the screw holes on the bracket with the screw holes on the unit, and then tighten the screws (5x5mm) on each side.
Note: the outer trim ring, sleeve and the metal strap are not used for method B installation.
5