APPENDIX
Troubleshooting Guide
The SunÞre Ultimate Receiver is expertly designed and built to provide years of
The following information will help you deal with common setup problems you may experience during normal use of your unit. If problems persist, contact your SunÞre Dealer for help.
No sound from one or more speakers
•Speaker cables may have come undone. Turn off your system and check the cables, and tighten the binding posts.
•An audio cable may have an inter- nal break.
•The volume level is low for the channels concerned. Recheck the calibration procedure (page 40).
•The Mute switch is on.
•The channel has not been turned on in the Speaker Size Menu (page 38).
•The correct surround mode is not selected. (Some DVD discs are stereo only).
•Note: In Source Direct mode, only the front left and right speakers are engaged. They must also be set to Large.
No subwoofer or poor output
•The subwoofer’s ampliÞer is off, or its controls are set low.
•Are all speakers set Large?
•SUB is not switched on in the Speaker Size Menu (page 38).
•Recheck the calibration procedure (page 40).
•Adjust the Crossover and check Bass Management (page
•See page 50 to Þnd the best loca- tion for your subwoofer.
•If the bass is weak during Dolby Digital or DTS playback, check the correct audio output is selected in your DVD menu, otherwise it may just play stereo into your Receiver and you won’t get the true LFE signal to the subwoofer.
Poor Tuning of Stations
•The antenna may be incorrectly attached.
•Stations not correctly tuned in, or is weak or off the air.
•You can improve reception by us- ing external antennas. Some cable TV feeds also offer FM reception.
The same AM station can be heard at different frequencies
•One wire of the AM loop antenna may not be connected.
•A loop antenna is required for AM reception, as it forms part of the
Full Automatic does not work
•Make sure the Fully Automatic but- ton is on (page 11).
In order to automatically choose the new input source, this mode senses the following active signals: Left audio signals, Video signals, Digital signals
Note that LD or DVD players sometimes put out digital signals even when the disc is paused or stopped. Make sure that any sources are turned off when not in use.
If a source is always active, the automatic operation may return to that input as the analog audio varies. In this case, you should try and turn off any unused sources, or turn off the automatic mode.
If you are listening to a mono source, make sure it connects to a left input, or use a “Y” cord to feed both left and right inputs.
There is no automatic selection of the Phono input, Tuner, or
Certain inputs cannot be se- lected
•Check the INPUTS menu of the OSD (page 34), and make sure that the input has not been dis- abled in that particular Zone.
No TV picture
•Make sure that the video input of your TV monitor is connected to the Main monitor output on the Receiver's rear panel.
•Check the VIDEO TYPE is cor- rect in the Inputs menu of the OSD (page 34). Select the type of video input you have connected, or choose AUTO.
•Check that your Monitor is se- lecting it’s correct video input.
•Check the video connection from your selected source component into the Receiver.
•Make sure that you are using the same video connections. For ex- ample, if your source is connected using
•If in doubt, try connecting the video output from your source directly to your TV monitor. This will help you narrow down the problem.
•Do not connect more than one type of video connection to the same input. Choose only the highest quality video type.
No Holographic Image
•It is essential that your front speak- ers are positioned correctly. See pages
•The Holographic Image is most effective in
No Tone Controls
•They will not work if you are us- ing the
52
User's Manual