S I G N AT U R E P O L I S H
Signature Polish is available from Signature Limited Laboratory,
W O L F PRO VENTILATION HOOD U S E & C A R E
CLEANING A N D CARE |
|
| ||
Most surfaces of your Wolf Pro hood are | D E C O R AT I V E R A I L | |||
stainless steel. Although resistant to most |
| Clean the decorative hood rail using warm | ||
stains, it is not totally impervious to damage. |
| |||
| ||||
| soapy water. Then hand dry with a clean, | |||
|
|
|
| |
G E N E R A L C L E A N I N G |
| soft cloth. | ||
| It is not necessary to remove the decorative | |||
|
|
|
| |
|
|
|
| |
|
| Salt and some cooking liquids may pit and |
| rail from the hood assembly. It should be |
|
|
| ||
|
| stain the surface. Always remove any film |
| cleaned in place. |
|
| or spills immediately. |
| Be careful not to pull or hang on the bar, as |
|
|
|
| |
|
| Avoid using abrasive cleaners. They will |
| this could damage the hood assembly. |
|
|
| ||
|
| permanently scratch the surface. |
|
|
P. O. Box 13436, Dayton, Ohio
Do not use steel wool pads.
Be careful not to soak the rotary switches. Although they are sealed, excessive moisture may cause damage to the controls.
A spray degreaser will remove fingerprints and greasy spatters. Spray on a cloth and wipe surface. Buff dry immediately to avoid streaking.
Use white vinegar and water to remove hard water stains.
Use a clean cloth or sponge, wipe with warm water and mild detergent. Rinse and dry immediately.
Apply a protective polish like Signature Polish (see side note) to the surface to maintain luster and protect against food stains. Apply the polish following the same grain direction as the finish.
S TA I N L E S S S T E E L F I N I S H
Use a soft, nonabrasive stainless steel cleaner like Signature Polish (see side note) and apply with a soft
Under no circumstances should you use a metallic or highly abrasive cleaner or cloth, as this will damage the finish.
16