Bakers Pride Oven CS71-CVMP15-SB manual Maintenance, 1c. Replacing the power indicator lamp module

pertoolsandAfter6-1REPLACINGousingequipmentlthesingTroublshootingPARTSonlyneededqualfortyBEVLESeachtblerepIacement(sectionparts5-.2)proctodtermineedurearethelistedsolution,atthebeginningrfertotheofappropriatethatproceduresction.below.The
6. MAINTENANCE
**CAUTION: All maintenance on BEVLES Heating Holding Ca	ts s uld be rformed by trained

6-1a. Removing the top mounted heating module. Required: No tools required

1.Unplug unit from power source.

2.Open top front door and remove water pan and baffles.

3.Using two people, lift the top mounted heating module straight up and off of the cabinet (Fig. 8)

4.Set module upside down on a heat resistant surface.

6-1b. Removing the front panel from the heating module.

Required: Medium (6') phillips screwdriver, Medium (6') flathead screwdriver

1.Remove all five screws from the face of the front panel (at the four corners and center top).

2.Gently lift off the front panel while guiding attached wires and thermometer probe to prevent damage. (Fig. 9)

3.Leaving wires attached, gently place front panel face down on a clean work space. (Fig. 10)

4.To replace front cover, reinsert thermometer probe into receptacle, guide wires back into place and reattach panel with the five phillips head screws.

Figure 8

Figure 9

Figure 10

Figure 11

Figure 12

Figure 13

6-1c. Replacing the power indicator lamp module.

Required: Wiring markers (color or number codes), Electrical tape

1.Remove front panel as found in section 6-1b.

2.Mark all the wires connected to the power indicator lamp module with a color code or number to make proper re-connection easy (Fig. 11)

3.Remove the wire nuts and free the power indicator lamp module wires.

4.From the back side of the front panel, depress the plastic tabs on the base of the indicator lamp module and push it out the front of the panel9. (Fig. 12)