SKETCH “C” - CLEANING THE BLOWER WHEEL
Blower Wheel
Set Screw (2) |
|
Wheel Puller Bolt 3/8” Hex | Motor |
4.SERVICING
1.The power supply to the unit must be disconnected prior to service.
2.Most of the service to this unit can be performed from the front and/or the control panel side.
3.For proper service, access to the control panel side of the unit is required.
4.It is necessary to have access to the back of the oven when the motor and/or contactor require service.
5.A system wiring diagram is provided in this manual as well as on the back of the service panel on the right side of the oven.
6.All service should only be performed by a
7.Call the factory
8.Replacement parts manual sent with unit should be saved for future use.
SKETCH “D” - OPEN RACK STAND ASSEMBLY INSTRUCTIONS
30” Legs
Top Left Angle
Top Right Angle
Restraining Plate for
Legs w/Casters
| |
Truss Head Screw |
|
w/Nut & Washer (8) | La |
| bel |
| F | |
| R | |
Open Rack Shelf | ON | |
T | ||
|
Rack Support
Label, Restraining Device
for Casters
½” Flat Washer (4 Corners Only)
½” - 13 x 1” Large Hex Head Bolt (12)
5/16” Flat Washer (4)
9