Bakers Pride Oven COH-ED, COH-ES General Instructions, Steam Injection Option

Page 6

IMPORTANT: The oven will begin to heat as soon as the door(s) is/are closed, the oven temperature is lower than the temperature set and the selector switch is in the “High” or “Low” cook position.

!

The thermostat indicator light will turn on and stay on while the oven is heating

!

up, and will turn off when the set temperature has been reached.

The door(s) interlock switch will deactivate the motor and heating elements and turn on the light when the door(s) is/are opened.

7.STEAM INJECTION OPTION

The solenoid valve for steam injection is mounted behind the service panel on the right hand side of the unit on COH-E and on the back of the unit on CO1-E. It is pre-wired at the factory. The electronic timer is pre-set at the factory.

A ¼” copper tubing with a compression fitting for water connection is provided on the solenoid valve. Be sure to check for leaks after installation.

OPERATING INSTRUCTIONS

1.GENERAL INSTRUCTIONS

a.This equipment has an electronic temperature control.

b.Due to increased efficiency of this oven, the temperature required for standard recipes may be reduced 50°F (30°C).

c.Always load each shelf evenly and space pans away from each other and the back and sides of oven to allow for maximum airflow around the product.

d.Large tempered glass window(s) and interior light(s) allow for a close check of the product making it unnecessary to open the door(s) too frequently.

e.Products cook faster in a convection oven as compared to a conventional oven, therefore, depending upon the product and type of pans used. Time saving may range anywhere from 20% to 50%.

2.SYSTEM OPERATING SEQUENCE

1.COOK ONLY ROTARY CONTROL

a.Close the oven door(s).

b.Turn selector switch to “High” or “Low” position. The green indicator light near the selector switch will be illuminated.

c.Turn the thermostat knob to the desired cooking temperature.

d.Upon reaching the set temperature, the amber indicator light near the thermostat will turn off.

e.Load the oven with the product to be cooked.

f.Remove the product from the oven when done.

2.TIMED COOKING ROTARY CONTROL

a.Close the oven door(s).

b.Turn selector switch to “High” or “Low” position. The green indicator light near the selector switch will be illuminated.

c.Turn the thermostat knob to the desired cooking temperature.

d.Upon reaching the set temperature, the amber indicator light near the thermostat will turn off.

e.Load the oven with the product to be cooked.

f.Turn the timer knob to the desired bake time and timer will begin counting down.

g.When the timer reaches zero, a buzzer will sound.

h.Turn the timer knob to “0” position.

I. Remove the product from the oven.

6

Image 6
Contents Full Size CO1-E & 1/2 Size COH-E Electric Convection Ovens Receiving Location & Minimum ClearancesCOH-E1 Direct Placement on Counter 3A.SET-UP / Mounting for COH-E1CO1-E2 Installation / Mounting 6 Legs Electrical Connections General InstructionsInitial START-UP CO1-E Power SupplyField Connections System Check Rotary ControlGeneral Instructions Steam Injection OptionCook & Hold Rotary Control Optional Steam Injection Rotary ControlOven Cool Down Rotary Control Cleaning Do not USE Steel WoolServicing 208V Wiring Diagram Star Connection COH-E & CO1-E DWG -71B 8/98 CO1-E Exterior / Interior / Elements / Controls / Door CO1-E COH-E Optional Steam Injection Not Shown Door Latch / Electrical Components Page BKI Limited Warranty Phone 864 963-3471 Fax 963-5316 Toll Free 927-6887