AEG DI 8610 manual Safety warnings, For user, For kitchen unit installer

Page 4

Safety warnings

for user

Always cover lighted elements, to prevent excess heat from damaging the appliance. In the case of oil, gas and coal fired cookers it is essential to avoid open flames.

Also, when frying, keep the deep frying pan on the cooker top/ cooker under careful control.

The hot oil in the frying pan might ignite due to overheating.

The risk of self-ignition increases when the oil being used is dirty.

It is extremely important to note that overheating can cause a fire.

Never carry out any flambé cooking under the hood.

Always disconnect the unit from the power supply before carrying out any work on the hood, including replacing the light bulb (take the cartridge fuse out of the fuse holder or switch off the automatic circuit breaker).

It is very important to clean the hood and replace the filter at the recommended intervals. Failure to do so could cause grease deposits to build up, causing a fire hazard.

for kitchen unit installer

When used as an extractor unit, the hood must be fitted with a 150mm diameter hose.

Falls ein Abluftrohr in Wand oder Dach mit einen Durchmesser von 125 mm schon besteht, kann der mitgelieferte Reduzierstutzen, 150/125 mm, verwendet werden. Zusammen mit dem Reduzierstutzen kann der Ablaufschlauch 125 montiert werden.

When installing the hood, make sure you respect the following minimum distance from the top edge of the cooking hob/ring surfaces:

electric cookers

600 mm

gas cookers

650 mm

coal and oil cookers

700 mm min.

The national decree on fuel-burning systems specifies a maximum depression of 0.04 bar in such rooms.

The air outlet must not be connected to chimney flues or combus- tion gas ducts. The air outlet must under no circumstances be connected to ventilation ducts for rooms in which fuel-burning appliances are installed.

75

Image 4
Contents Page Printed on recycled paper AEG putting words into action Contents For kitchen unit installer Safety warningsFor user Page Introduction Extractor versionFilter version Hood Operation C D E F G HResetting the saturation indicator Control device for grease and activated charcoal filtersGrease filter LED D Activated charcoal filter LED EMaintenance and care Metal grease filterOpen the metal grease filter Hand washingCarbon filter Cleaning/replacing the carbon filterMounting Changing the light bulb Special accessories CleaningTechnical assistance service Guarantee conditions European GuaranteePage Mounting accessories included DimensionsMaximum absorbed power Technic DetailsSafety warnings for the electrician Electrical connectionInstallation Fig 273 244 190 14,5 214 Page 13F 13A