Pitco Frialator E400T, E500D operation manual Filtering Instructions, Filter Paper Replacement

Page 10

OPERATION

FILTERING INSTRUCTIONS (continued)

e.Ensure that flush hose is pointed into tank and place Filter ON/OFF ( I/O ) switch in the ON ( I ) position. The pump will begin to return shortening/oil to the tank.

WARNING

For your safety, NEVER allow flush hose nozzle to point away from the tank while filtering.

f.Carefully rinse the tank back and sides with stream of returning shortening/oil. You can use the cleaning brush and cleaning rod to aid in removing debris from the tank.

g.Once all debris has been rinsed from the tank, close the drain valve and allow the tank to refill. To ensure that filter lines are purged, allow the filter to run for 15 seconds after all shortening is returned to the tank. Additionally, it may be necessary to add a small amount of shortening/oil to bring the shortening/oil back to the OIL LEVEL line.

h.It may be necessary to repeat steps d through h if shortening/oil quality is not acceptable. Otherwise, you may now turn the appliance on per the instructions in this manual and resume operation.

To ensure proper operation and sanitary conditions, the filter system should be disassembled and cleaned with hot water and mild detergent daily. Refer to the CLEANING AND MAINTENANCE section of this manual for instructions.

FILTER PAPER REPLACEMENT

For models with filter option refer to the following instructions

a.Detach the pickup tube from the filter pickup assembly by unscrewing it (counterclockwise), at the knurled fitting, from the threaded fitting on the filter screen.

b.Slide off the filter paper clip and remove used filter paper from filter screen. Replace with new filter paper, ensuring that the hole in the paper is on the top, so that threaded fitting in filter screen protrudes through it.

c.Fold filter paper to the underside of the filter screen and replace filter paper clip.

d.Re-attach filter pickup tube to the filter screen by screwing it (clockwise) into the threaded fitting in filter screen.

e.Reinstall the filter pickup assembly into the filter system by placing the newly covered screen portion of the assembly into the filter pan and connecting the quick disconnect on the filter pickup assembly into white donut fitting on the left-hand side of the appliance. Ensure that it snaps tightly and securely into donut fitting.

You are now ready to filter the shortening/oil in your appliance. Refer to the FILTERING INSTRUCTIONS section of this manual for instructions.

L20-258-UK Rev.01 8/16/04

7

Image 10
Contents E400, E400T and E500D For Your Safety Table of Contents Leg/Caster Installation and Leveling AssemblyChecking Your NEW Pitco Appliance Installation Clearances InstallationElectrical Connection Initial Cleaning Types of Fire Extinguishers and Detection EquipmentFilling the tank with solid shortening/oil Filling the TankFilling the tank with liquid shortening/oil Operating InstructionsAppliance Start-Up Appliance Shut-down Filtering InstructionsFilter Paper Replacement Filtering InstructionsWeekly Cleaning Daily CleaningFilter Pan and Filter Pickup Assembly Cleaning Boil Out ProcedureFilter System Cleaning Thermostat Calibration Check Thermostat CalibrationTrouble Shooting TroubleshootingL20-258-UK Rev.01 8/16/04 L20-258-UK Rev.01 8/16/04 L20-258-UK Rev.01 8/16/04 L20-258-UK Rev.01 8/16/04 L20-258-UK Rev.01 8/16/04 L20-258-UK Rev.01 8/16/04