Pitco Frialator E400T, E500D operation manual Filter System Cleaning

CLEANING and MAINTENANCE

WARNING

At operating temperatures, the shortening/oil in the appliance is VERY HOT and can cause severe burns. Do not let the hot shortening/oil touch your skin or clothing. ALWAYS wear insulated, shortening/oil proof gloves, protective clothing and eyewear when working on a hot appliance.

For models with electric thermostat option refer to the following instructions.

a.Drain the shortening/oil from the appliance and discard or save for reuse. Remove the element screen. Close the drain valve and fill the tank with warm water and non-caustic detergent. For best results, use Pitco Cleaner. A sample packet is included with your new appliance.

b.Restart the appliance as described in this manual and set the thermostat to 200°F (93°C). Bring the water to a slow boil. DO NOT allow the water to boil excessively as this will cause excessive foaming and boil over.

c.Allow the appliance to soak for 20 minutes to soften shortening/oil deposits. Use the cleaning brush to scrub and remove any residue from the tank, elements and tank walls.

d.When finished drain the water and wipe the tank dry with a soft clean cloth.

e.Ensure that the drain valve is closed and replace the element screen.

f.You may now refill the tank with shortening /oil per the filling instructions in this manual.

For models with Compact Computer, refer to the following procedure:

a.Drain the oil from the appliance and discard or save for reuse. Remove the element screen. Close the drain valve and fill the tank with warm water and non-caustic detergent. For best results, use Pitco Cleaner. A sample packet is included with your new appliance

b.Restart the appliance as previously described in this manual.

c.Press the ON/OFF (I/O) and T4/T8 key simultaneously.

Control will indicate that it has entered “boil” mode and will cycle around a fixed setpoint of 195°F (90 °C), preventing the appliance from boiling over, while allowing the operator to clean the appliance tank while.

d.Allow the appliance to soak for 20 minutes to soften shortening deposits. Use the cleaning brush to scrub and remove any residue from the tank, elements and tank walls.

e.When finished turn the appliance OFF (O), drain the water and wipe the tank dry with a soft clean cloth.

f.Ensure that the drain valve is closed and replace the element screen.

g.You may now refill the tank with shortening/oil per the instructions in this manual.

Filter System Cleaning

WARNING

The power supply must be disconnected before cleaning and servicing this appliance!

The filter system should be thoroughly cleaned AT LEAST once a week. This should include a thorough wipe down of the entire non-removable components with a rag and mild detergent. DO NOT spray or pressure wash any non-removable part of the filter system!

L20-258-UK Rev.01 8/16/04 9