Duct Cover Installation
11.Slide the inner duct cover up and secure to the telescopic stack with four (ST 3 x 15) screws (provided). Refer to Figure 7.
12.With assistance, slide the outer duct cover to the blower unit and ask assistant to hold steady until step 15 is completed.
13.Attach glass canopy with LCD screen underneath the blower unit. Make sure blower unit is inside the housing connector. Refer to the PARTS LIST on pages
14.Secure the housing connector to the blower unit with eight (M5 x 15) screws (provided) as shown in Figure 8.
15.Ask assistant to slide outer duct cover downward so it rest within the grooves of the glass canopy.
Connection to LCD Screen
SAFETY WARNING
RISK OF ELECTRICAL SHOCK. THIS RANGE HOOD MUST BE PROPERLY GROUNDED. MAKE SURE THIS IS DONE
BY QUALIFIED ELECTRICIAN IN ACCORDANCE WITH ALL APPLICABLE NATIONAL AND LOCAL ELECTRICAL CODES. BEFORE CONNECTING WIRES, SWITCH POWER OFF AT SERVICE PANEL AND LOCK SERVICE PANEL TO PREVENT POWER FROM BEING SWITCHED ON ACCIDENTALLY.
16.Remove front baffle filter (directly behind LCD screen). When facing the LCD screen, turn knobs slightly to left to release baffle filter. CAUTION: DO NOT OVERTURN KNOBS.
17.Connect the wires according to connector color to the blower unit.
18.Place baffle filters back in place.
Final Assembly
19.Turn power ON in control panel. Check all lights and fan operation.
20.Make sure to leave this manual for the homeowner.
Figure 7
Figure 8
7